POWERSAVE MODE - Computers & Internet

On the front panel of the printer, locate the printer configuration menu. Then find the PowerSave option and select the time that you want to delay before unit enters powersave mode.

You need to enter the bios when it powers up and disable the power saving settings.

I think its the f11 key or del key to enter the bios immediately you see a display screen when you switch it on then navigate to the power saving settings area in the bios.

Have talked to octopus and they advise unit cannot be changed from the 6-10 minute powersave then turn off mode so this unit is useless and why so many are on Ebay

disconnect all the cables from the back of the monitor except the power
you would see a test screen
if it still go to power safe while you are in the test page you monitor cud be bad better buy a new one as usually repairs are expensive

If the player is turning off on it's own it either need to charge or you have the powersave mode on. Go into the settings and go to powersave and set the amount of time that you want it to last.

The reason you can't change the settings on the powersave mode is probably because you are trying to surf the menus whilst the mode dial is on either the "IA" or "Preview" mode. Move the dial setting to any other mode and work through the menus, and you should be able to update the Powersave function from 1-2 minutes to 5 or 10 minutes. I find that 5 mins. works best for me. \

Good luck!

The LJ 4100 detects the paper size in tray 2 automatically. If you print a configuration page:
MENU them INFORMATION then ITEM then CONFIGURATION PAGE then SELECT.
The page will print and show what size paper the machine thinks is in Tray 2 if it says LEGAL and you have LETTER you need to check the paper back stop in tray 2.
The back stop sets the length of the paper if it is not at Letter (8 1/2 x 11) the machine will not detect LETTER. Even if it just a little bit off or between positions.

If it is set at LETTER then you may have bad switches in the machine that are operated by the tray.
Or the arms on the tray that operate the switches are not moving properly.
You will find the arms on the rt, side of the tray and feel them change position when you move the backstop.
Hope this helps.

I see that your machines are not on a network but do they have network cards installed?
The jet direct card can cause various problems. Look to see if they are in your machines and remove them if they are.
If that doesn't work you can print an event log and see if any errors corespond with the condition.
Hope this helps

If it's going into powersave mode, it usually means it's not getting a signal from the video card. Try plugging this monitor into another machine or laptop and you should be able to tell if that's the issue.

i have a mju300 with the same housing.when i put the camera in the housing it is on but i turn the screen off.this is the button that is next to the screen and next to the ok button.when i want to use the camera i just turn the screen back on.

hope this helps

adrian