Question about Pioneer DEH-P3100 CD Player

1 Answer

Installation/removing i need to know if there is an easy way to pull deck out to plug in new aux connection

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    MVP:

    An expert that gotĀ 5 achievements.

    Master:

    An expert who has achieved Level 3.

    Sergeant:

    An expert that hasĀ over 500 points.

  • Master
  • 462 Answers

Dear ecdpsp

Since the AUX in ur deck is at the back, to access this u can use a philiphs flat screwdriver and slowly push the deck out from left and right sides. But before that u can easily remove the outer border panel.

Posted on Feb 07, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I want to connect my Moto g to my e220 mb. The car has a Nokia cradle but is not blue tooth enabled. Is there a cost effective solution?


is there a tape deck
get a bluetooth or wired cassette

no tape deck pull radio out and find aux input and plug in a audio cable and replace the radio

Nov 15, 2016 | Nokia Cell Phones

2 Answers

How can I hook up the snowblower attachment?


if its a garden tractor then you will first need to remove the mowing deck , this is easy if you have something to run front wheels up on to allow you room to pull deck out the side ,set deck height all the way down, save the drive belt . save the deck pins . locate the front chassis mounting arms and drive up to blower allow rear mounting arms to go between the two front wheels till the back of blower meets the front of chassis mounting arms (tight fit) install pins at all four points of contact , install belt to blower and front pto of machine (install any guards for belt) then raise blower from ground with deck height adjustment lever (it might feel heavier) test it to prove good contact your done
if its a three point (this is the reason I own one know) you back up to blower lower the mounting arms , engage the quick pins , install the drive shaft between the blower and machine with a quick spring snap , connect top link to tractor get back in seat and start machine raise three point an go !!

Jan 19, 2016 | Garden

1 Answer

I need to know how to install a cd player in my 1997 jeep wrangler sport.


My suggestion would be to buy a wiring harness and a dash mounting kit. After that unscrew or pull out the console/dash part thats around your factory deck. Then unscrew the bolts/screws holding the factory one in place. Remove it. Plug the wiring harness into the factory wire plug. Pull harness wires through the mounting kit. Attach the corresponding colored wires from the harness to your new deck. Slide your deck into the mounting kit and secure it in place. Most decks have little prongs that you can pry up to **** up against the mounting kit so it wont slide out without pushing those down (makes it more secure and harder to steal). Place deck with mounting kit into area factory deck was. Put the screws/bolts back into place tightly. Place console/dash part back on. You will need the mounting kit (99% of new decks are smaller than the factory). Wiring harness is optional but recommended.

Jun 22, 2010 | Panasonic CQ-C7105U CD Player

1 Answer

How do i connect an aux cord to my head unit


You can go to radio shack and grab a 3.5mm to 3.5mm cable. make sure that is male -to - male. Some decks are equipped with an AUX IN in the front and some in the back and then some have both. This wire will resemble the same input end of an earphone plug. Once you have your device plugged in then just press the SRC button on your deck till it says AUX, AUX IN, or Audio. Let me know if this helps

May 20, 2010 | Pioneer DEH-P6800MP CD Player

1 Answer

My Dual amp wont put out power when deck is in aux or ipod modes.


my pioneer deck does the same thing its just that when in aux mode, it will not play loud enough, i have to turn it up all the way just to hear a little sound, and i really dont know y, but when in those mods, it usually doesnt put out sound on ur subwoofer or amp rca wired on back of ur deck, and usually they do, but the power is not large enough for ur amp to pick the frequency up from ur rca wire connections. that also has happened to me before, i just usually ignore it, and just burn an mp3 cd w like hundred songs, so i dont need a ipod or mp3 player for aux.

hope i was help :)

Aug 14, 2009 | Alpine Car Audio & Video

1 Answer

Removing audio deck from 2003 Chevy Astro


It is very easy: With parking brake applied, shift to 1st gear, then remove the dash panel that goes around the instrument cluster and the stereo. Once the panel is off, you there is a black tab on both of the side of the unit that you push down, and then pull the unit out.
To install an aftermarket deck, I recommend a specific wiring harness adaptor, that you splice onto the connector included with the new deck - so that you can reinstall the original one if/when you want to sell the vehicle. If you don't, you have to cut the original harness wires, and connect them in the correct orentation (which is tough, as there is about 20 wires!)

The dash panel installs in the same way: shift to 1, then push into place.

Apr 29, 2009 | 2003 Chevrolet Astro

1 Answer

Remove audio deck from 2003 Astro


It is very easy: With parking brake applied, shift to 1st gear, then remove the dash panel that goes around the instrument cluster and the stereo. Once the panel is off, you there is a black tab on both of the side of the unit that you push down, and then pull the unit out.
To install an aftermarket deck, I recommend a specific wiring harness adaptor, that you splice onto the connector included with the new deck - so that you can reinstall the original one if/when you want to sell the vehicle. If you don't, you have to cut the original harness wires, and connect them in the correct orentation (which is tough, as there is about 20 wires!)

Apr 29, 2009 | 2003 Chevrolet Astro

1 Answer

Aux Input on Back?


Aux input on the back depends if there was a aux button on the front and the brand of deck. If one is there then you dont need Best Buy to do it. removing the deck is not as hard as people make it seem. The best way to remove the deck to check is find a manual for removal; exp: chiltons, hayne or even get it from crutchfield. Be careful though, some decks may have the aux button and a 3.5mm jack in the back but the jack is sometimes used for a remote. So get the mauals for the deck you have and the manual for removal.

May 21, 2008 | JVC KD-DV4200

3 Answers

Auxilary RCA inputs have no volume control


Your problem stems from the fact that the CDA-7892 is not equipped with an RCA aux-input jack. If you're plugged into RCA connectors at the back of the head unit, they're outputs, not inputs. The sound you hear is just feeding back through the outputs and into the head unit's amplifier. If you want to play your iPod through this head unit, you need to purchase either the auxiliary input adapter (KCA-121B) or iPod adapter (KCA-420i).

Mar 15, 2007 | Alpine CDA-7892 CD Player

Not finding what you are looking for?
Pioneer DEH-P3100 CD Player Logo

Related Topics:

50 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pioneer Car Audio & Video Experts

The Knight
The Knight

Level 3 Expert

75846 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Marvin
Marvin

Level 3 Expert

82322 Answers

Are you a Pioneer Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...