Electric range is over 15 years. F-1 on comes on and will not

This is a recurring problem with certain KitchenAid ranges. I have a 15 year old dual fuel 36" range and have replaced the temp sensor twice, and now it has gone out again. $8,000 piece of junk the oven has been used. RARELY in 15 years.

call Sears if it is under 1 year old

The control panel is super easy to change out. There is 1 ribbon cable to plug in. Here is the part to order.

All parts come with a 365 day, any part, any reason return policy.

Sounds like that switch and knob needs replacing.

Usually this is a failure in the electronic control. We rebuild a lot of these.
Best Regards,
Bruce
www.fixyourboard.com

Hi,
Before you go working too hard to get you oven to go into the self clean mode....check out this tip...


http://www.fixya.com/support/r3969401-self_cleaning_oven_problem

heatman101

1) check the wireless channel set in the Zhone 6211-I3-200 Router and to your computer. it must be the same
2) make sure you are using the wireless signal within the same floor or else your router's wireless capability will need a signal booster for wireless signals

Have you resolved your oven problem ? If so, what was it ?

I have the same exact thing going on....

Brad

F1 is a failed thermistor control in the control board. Board must be replaced to fix. Part is in vicinity of $120.00

1. Mostly Loose contacts in video section that means CRT Neck board dry points checke it.
2.Pl check VGA Cable RGB signal pins 123 to ground 75 Ohms (on OK condition).
3.check 5v supply
4.check SDL and SCL signals.