- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
No wireless on this laptop you would need to use a usb wireless adapter
roduct Details and Features
Pentium III 650 MHz
14.1 in. TFT Active Matrix
Microsoft Windows ME
Max Supported RAM
Installed Cache Memory
Hard Drive Capacity
CD / DVD
CD / DVD Type
Optical Drive Read Speed
3.5" 1.44 MB floppy
TFT Active Matrix
Installed Video Memory
Audio Output Type
Microsoft Windows ME
Integrated Network Card
Data Link Protocol
Analog Modulation Protocol
Battery Run Time
WEP key is defined by the person who set your wireless router up. You
will not be able to find out what the WEP key is, but you CAN change it
if you have physical access to the router. If you are trying to connect
to your wireless router and can't remember the WEP, then walk over to
the router and on the back or bottom of it is a small little hole that
you can fit a pen or paper clip into. Press the paper clip into the
little hole for 10 seconds and release. This will reset all the settings
on your router back to default and will allow you to access your
Note: doing this will take away all of your
wireless security so make sure that you know what you're doing before
messing with it!
Thanks and please rate if this helps you at all :).
You have not assigned ip to your NIC Card thus it is showing yellow warning sign. Just double click on double computer icon in system tray, select properties, select tcp/ip, click properties, assign ip address & subnet mask to that. For eg: ip address 192.168.0.2 , subnet mask: 255.255.255.0.
You apparently don't have downloaded all drivers and software needed.
I'd go to:
Install the software in the following sequence:
1. Download and install Sun StorEdge SAN Foundation software 4.2 packages and
See Sun StorEdge SAN Foundation Software 4.2 Installation Guide, 817-1244.
2. Download and install the appropriate JNI 2 Gb PCI Single and Dual Port HBAs
packages and patches.
See JNI 2 Gb PCI Single and Dual Port Fibre Channel Host Bus Adapters Release Notes,