Re: needing assistance on problem with my fuji digital...
When ever I try to connect the camera to PC I am getting a message "Communication Error". I have done everything possible in my part but the error never goes. But when I put the camera in Pict Bridge it works. My camer is FujiFilm FinePix F 650. Could you please help me out. My e mail ID is firstname.lastname@example.org
Thanks and regards
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The lens Is trying to close properly but the focus mechanism has a problem, most likely jammed, so the lens cannot correctly close or work properly.
It will need to be opened up and reset.
Please email me. My email address is listed in my tips section on my profile.
The problem is that the lens has become stuck in the barrel. There are some DIY solutions you could try, but the
probability is that you will have to get it fixed by a professional.
these at own risk as it may further damage the camera.
try connecting your ac adapter or usb cable.
Try holding the
shutter button while switching on the camera.
Look at the lens ,
and if some of the lens 'circles' is misaligned or not concentric then
try wiggling it (while holding camera lens down).
pushing or pulling the lens when it extends but this is risky as it may
cause the lens barrel to slip out of its guidance system.
way to do this is to place the camera lens down on a hard surface and
then power it up. Be sure to use a soft cloth or something similar as to
not scratch your lens or casing. Let the lens push the camera up and
down a few times and sometimes the little resistance provided by the
camera is enough to get things going again.
Try hitting your
camera near the lens on the body with the soft tissue on the palm of
Other than that , I would take the camera to a repair
center for a evaluation to see if it would cost more to repair than to
replace the camera.
If it is still under warranty I would suggest
you take it in before trying any of these steps and remove any
off-brand batteries or accessories as some stores are really fussy about
warranty repairs on camera's with non-brand accessories.
I had the exact same problem in September 2007 (must be built in obsolence). I sent mine to Fuji's repair center to get repaired. Unfortunately, it becomes a decision of whether to get it repaired or buy a new one (repair cost ~$160). The kicker is now the flash will not work. I get a message/warning of camera shake. The manual says it's something to do with the shutter speed but no mention on how to correct it. So it becomes another decision of do I throw more money at it (send back for repair) or bite the bullet and buy a new camera.
Usually down to the lens block assy being faulty.Is the lens retracting and opening properly?.It usually turns out to be worn gears in the lens drive assy or the result of a fall.Either way will be expensive repair!My advise is check and see whether camera is covered by insurance for accidental knocks.,