Question about Whirlpool GEW9200L Electric Dryer

2 Answers

My dryer wont start

My whirlpool duet electric dryer wont start when i push the start button. the control panel turns on and when i push start it clicks like it's going to turn on but it never does??? can anyone help me wit this???? i need my dryer!!!!!

Posted by on

  • tam1601 Jan 09, 2008

    Push power button, indicator lights come on, sensing light comes on. Push start button. Dryer makes a click and nothing happens. Pushed the sequence of buttons to do a system check. 6E flashes on the time readout.

  • mtkosz Apr 29, 2008

    Same problem, I've tried the 3 sec end of cycle reset but still nothing. My model # is GEW9250PW1

×

Ad

2 Answers

I had the same problem. Vacum the vent port of the dryer after cleaning with bristle brush wand. Then clean the lint trap with the cone shaped bristle brush. The dryer should start working. Also you will need to investigate your vent to the outside, most likely the is a clog.

Posted on Jan 24, 2008

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 262 Answers

Check and see if you have 220 volts to your dryer using a volt / ohm meter find the cord and remove cover take meter and go across (1 test lead on left and one on right) side of cord there should be 220 volts.check this and get back to me. if no 220v trip breaker back and forth and try again

Posted on Dec 29, 2007

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Whirlpool duet does not turn on when the power button is pushed no lights come and no sound the interior light works and then theres the odd time you push the power button and it works fine


sounds like the door switch/latch is going bad. You can test it here is a website that will help:

http://www.partselect.com/dryer+dryer-wont-start+repair.htm

Dec 26, 2010 | Whirlpool GEW9250 Electric Dryer

1 Answer

Control lock light on and wont start. basement is humid and not sure if that has anything to do with it


Are the controls locked ?? if so push and hold for three to four seconds the end of cycle signal volume button on right side of control panel.that will unlock the controls..If it still wont run you may have a blown thermal fuse...... Good luck hope this helps

Aug 22, 2010 | Whirlpool Duet 7.0 Cu. Ft. Super Capacity...

1 Answer

Dryer wont turn on just has a click sound when start button is pushed


Hi,
A dryer may not start for many reasons...
This tip that I wrote will help you to figure out what is happening...

http://www.fixya.com/support/r4460438-dryer_repair_dryer_will_not_start

heatman101

Apr 08, 2010 | Whirlpool Duet 7.0 Cu. Ft. Super Capacity...

2 Answers

My whirlpool dryer just beeps when you try to start it. The panel is lit up the door is shut, push start and it just beeps...any idea what the problem is


To unlock the Control Locked feature:
Press and hold the End Of Cycle Signal button for 3 seconds to turn this feature off.

NOTE: When the dryer is running and Control Locked light is on, the dryer can be stopped by pressing the Pause/Cancel button, but cannot be restarted until the control is unlocked.

If holding doesn't unlock the feature, it is likely a faulty interface. I am having the same problem with my Whirlpool dryer and it is the interface, but it seems that a lot of people are able to correct the issue just by pressing the End of Cycle button for 3 minutes.

Here is a link to parts, numbers, and prices from Sears:

http://www.searspartsdirec t.com/partsdirect/getSubComp.pd?modelNumber=GGW9250PW1&productCategoryId=0151200&brandId=1198&modelName=RESIDENTIAL-DRYER&diagramPageId=00001&componentDescription=TOP%20AND%20CONSOLE%20PARTS&documentId=W0508037&blt=06


Jan 09, 2010 | Whirlpool GEW9250 Electric Dryer

2 Answers

Dryer wont start - no lights


Dryer door does not think it is closed. There is a sensor on the top of the door that is probably not making contact with the door. Trying pushing the top part of the door and holding it then press the start button.. if the unit starts running then you know what it is. I just had one of these dryers delivered today and had to find out about this by myself tonight!!

Apr 30, 2009 | Whirlpool WED9500T Electric Dryer

1 Answer

Dryer wont start


look under control panel look for a burned spot or burned wires some thing is throwing the breaker under the control panel one of the controls may be bad with this kind of dryer may have to replace controls

Apr 07, 2008 | Whirlpool GEW9250 Electric Dryer

1 Answer

Whirlpool duet ggw9250pl1


On Duet models, Press and hold the End of Cycle Signal button for three seconds. This will turn off the Control Locked feature.

Jan 02, 2008 | Whirlpool GEW9250 Electric Dryer

Not finding what you are looking for?
Whirlpool GEW9200L Electric Dryer Logo

347 people viewed this question

Ask a Question

Usually answered in minutes!

Top Whirlpool Dryers Experts

Sal De

Level 3 Expert

2699 Answers

Craig Butler
Craig Butler

Level 3 Expert

1723 Answers

Marvin
Marvin

Level 3 Expert

82322 Answers

Are you a Whirlpool Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...