Question about Car Video Players

1 Answer

Car tv how do i get car tv to fit in peugeot 306

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert who has answered 200 questions.


    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 216 Answers
Re: car tv

Where would you like car tv to fit on car?
Size of tv and much information would helpful so we can help, OK?

Why not hook up dvd player?

Posted on Dec 26, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

2 Answers

How to unlock codelock on pu 1562a

For Clarion/Peugeot radio code from serial number go to Gumtree, search clarion radio code.....cheaper than main dealer!

Jun 17, 2014 | Clarion VS735 Car DVD Player

1 Answer


Prob a dirty read eye or corroded laser tracking mechanism. requires removal, dis-assembly, and eye cleaned dry w/ Q-Tip or alcohol then dried w/ Q-Tip. Clean mech bars. same way. then 3-n-1 oil on q-tip lightly on bars

May 05, 2014 | Blaupunkt DVD-ME3 Mobile DVD w/ TV Tuner...

1 Answer

Does this unit fit into a 2007 montana van

This unit will fit into your van. There will be extra space in the dash after you install it. The standard measurement technique for head units is DIN. A single-DIN unit is the normal size of a head unit. Your stock unit is a double-DIN unit. The Clarion NZ500 is a single-DIN. It will fit, with space to spare.

Mar 08, 2011 | Clarion NZ500 Car Video Player

1 Answer

Screen wont go in on my pioneer avh-p5700


First of all there could be a problem with your slide in mechanism. This could be a factory defect or it could be that the person who installed the Avh P-5700 didnt install the deck sleeve in correctly. Alot of times we the installers face an issue trying to fit a head unit or slide in tv unit like yours with space, unfortunately some vehicles have a very tight or minimal slide in space for aftermarket radios or units like the AVH. The problem that we face is that when A unit like yours fits in forcefully due to space restrictions it will apply pressure on the units slide mechanism and the protection sensor will push the screen back out because it does not properly fit in , these units are so sophisticated that the slightest pressure will make the screen slide back out or not accept the screen in at all. Try to readjust your sleeve and the space around the sleeve if not my friend you have to get custom, which could be an issue if you dont have the skill to perform these tasks.

Good luck my friend,


May 23, 2010 | Pioneer AVH-P5700DVD Car DVD Player

1 Answer

Lost 1 split pin from front brake caliper where can i get 1 from?

Call you nearest Peugeot dealer spares dept to get a replacement pin and install it ASAP. You can buy single pins and they may even let you have one for free if you ask nicely.

Oct 13, 2009 | Jensen VM9510 Car DVD Player

1 Answer

Fitting parking sensors on peugoet 4007

It is possible to fit for any car. You have many brands to choose from.

Sep 19, 2009 | Pyle PLPSE6 Reverse Parking Curb Sensor...

1 Answer

I have just bought a car with an overhead tv i dont know how to get power to it

    Headrest TV
  1. Step 1 Disconnect the headrest from the car seat and remove its upholstery. Trace the outline of the TV's mounting frame onto the foam cushioning with a permanent marker.
  2. Step 2 Cut a hole into the foam using a razor knife for the frame to fit into. Using the frame as a guide, whittle into the hole until it is deep enough for the frame to fit into. Glue the frame into the hole with contact cement and poke another hole into the foam with a screwdriver where the frame's cable hole is.
  3. Step 3 Place the headrest's upholstery cover back on and cut the fabric away where it is over the frame.
  4. Step 4 Place the TV into the frame once the contact cement is dry and hard and run its cable through the other hole. Connect the TV to its tuner console with audio/video cables and store the tuner under the seat.
  5. Step 5 Connect the TV's power adapter cable and route it so it can plug into a cigarette lighter adapter. If it doesn't use one of these, it will have a three-way cable where one connects to the car starter, another to a constant 12-volt source and the last one to a good ground. Disconnect the negative battery cable before connecting any wires
  6. Overhead TV
  7. Step 1 Make sure there is a metal sheet installed in the ceiling below the headboard. This is needed to mount the overhead player onto.
  8. Step 2 Pull away the upholstery on the ceiling. This might require a solvent that will remove the upholstery's adhesive. Insert a plywood or metal sheet between the headboard and upholstery and glue it to the upholstery.
  9. Step 3 Mount the TV set to the ceiling, making sure the screws for the TV's mount are securely screwed into the sheet within the ceiling.
  10. Step 4 Route the wires to the engine compartment if the TV doesn't use an adapter plug for the cigarette lighter. With the negative battery cable unplugged, connect the TV's red wire to the starter's electrical connector, the yellow to the battery or other 12-volt source and the black to a metal ground like on the chassis.
  11. Dash TV
  12. Step 1 Unplug both battery cables from the car's battery, starting with the negative terminal.
  13. Step 2 Remove the stereo from the car. Pry away and remove any trim panels on the dash, then unscrew the mounting screws on the stereo and disconnect the electrical connectors. Some stereo units have an anti-theft mounting system requiring special tools that fit into holes on the stereo front to release its mounting clips.
  14. Step 3 Place the TV within an installation kit designed for your model carmag-glass_10x10.gif. Connect the antenna's cable to the TV and mount the antenna on the outside of the car; the trunk or the roof near the door frame are two possible locations. Route the cable along the weatherstripping or secure it to the side with cable ties.
  15. Step 4 Connect the TV to its tuner box with RCA video (composite) cables and store the tuner somewhere secure, like the glove box. Wire the TV to the radio antenna and stereo connectors with a wiring harness designed for your car, which can be purchased at a car audio supply store.
  16. Step 5 Mount the TV into the stereo's old spot within the dash, fasten all the mounting screws and replace the trim panels. Reconnect the battery cables once the set is mounted, starting with the positive terminal.
i hope this will can send a message if you not satisfied

Sep 10, 2009 | Necvox Car Video Players

1 Answer

Car code how do i enter it

Free Radio Code Entry Instructions for all makes and models can be found here

Jan 31, 2009 | Clarion MAX385VD Car DVD Player

Not finding what you are looking for?
Car Video Players Logo

Related Topics:

86 people viewed this question

Ask a Question

Usually answered in minutes!

Top Car Video Players Experts


Level 3 Expert

6993 Answers

The Knight
The Knight

Level 3 Expert

66476 Answers

xxxxxx xxx

Level 3 Expert

4679 Answers

Are you a Car Video Player Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides