Question about Hotpoint 24 in. HDA3400G Built-in Dishwasher

Open Question

How to dismantle and clean macerator - Hotpoint 24 in. HDA3400G Built-in Dishwasher

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Whining noise after the flush is filled and the noise keeps on but if the macerator is given a gentle kick the noise stops! Do I need a new Macerator?


sounds like there could be a blockage inside which is effecting the pump or the float switch look on the saniflo website for instructions how to clean etc or phone there tec department

Dec 09, 2010 | Saniflo SaniPlus-Round SaniPlus Macerator...

1 Answer

Pump cycles often


The following are the possible problems and solutions:
  1. The tank flapper (Flush Valve) leaking allowing water into bowl. Make sure flapper is fully seated. If flapper is fully seated and still is leaking replace flapper.
  2. Faulty Non-Return Check Valve, water leaking back into Macerator. Clean and Inspect check valve replace if after clean water still flows back into Macerator.
I hope this answers your question and gives you a few more places to look. Please rate the answer on it's helpfulness. Good Luck and have a great day. Jeff

Apr 06, 2010 | Saniflo SaniPlus-Round SaniPlus Macerator...

1 Answer

My saniflo compact has stopped working. When switched on it just makes a noise but nothing happens. The noise just continues and doesnt stop. Any ideas


http://www.saniflo.com/pdf/install/48_US.pdf
This link has dismantling instruction's.

Check for something blocking the macerating blades or defective capaitor. See the dismantling page on the above link.
Maybe it will be as simple as removing a blockage hanging it up. Hope this will be helpful to you.


Apr 01, 2010 | Home

1 Answer

Pump wont stop


The following are the possible problems and solutions:
  1. The tank flapper (Flush Valve) leaking allowing water into bowl. Make sure flapper is fully seated. If flapper is fully seated and still is leaking replace flapper.
  2. Faulty Non-Return Check Valve, water leaking back into Macerator. Clean and Inspect check valve replace if after clean water still flows back into Macerator.
  3. Check micro switch, the micro switch turns on pump when the water level reaches to a determined level. Location of switch is in the pressure chamber. Check to see if switch is sticking. Note: For safety Macerator should never be operated with lid open
I hope this answers your question and gives you a few more places to look. Please rate the answer on it's helpfulness. Good Luck and have a great day. Jeff

Mar 27, 2010 | Saniflo & Saniplus& Macerator Pump

1 Answer

Replacing the seal.


Hi you could try soaking it in warm water to make it soft then it might stay on

Jan 24, 2010 | Saniflo & Saniplus& Macerator Pump

1 Answer

My turboflush macerator does not take all the


indicates that the unit may need cleaning /descaling. alternatively the 22mm pipework (outlet) may be partially blocked

Dec 27, 2009 | Saniflo & Saniplus& Macerator Pump

1 Answer

Saniflow keeps on macerating after flushing, and I have to isolate it from the mains


Sounds like a stuck float switch .. probably due to gunk inside the macerator. You'll need to empty all of the water out of the WC, cisterm, isolate the electricity and disconnect the saniflo (i.e. take out WC and cistern), open up the saniflo and give it a good clean

Good luck

Dec 26, 2009 | Saniflo SaniPlus-Round SaniPlus Macerator...

1 Answer

Saniflo Macerator Noise


If it's a one shot cleaning and not an ongong additive, bleach can be used to dissolve the tissue.

Charlie

Aug 03, 2009 | Saniflo & Saniplus& Macerator Pump

1 Answer

My macerator turns off and stops working for 10 - 15 minutes


the macerator is over heating.check the maintenance opening and clean it ,but you may need a more powerful macerator,some are made only for flushing systems (as in toilets) a pro-longed use may be making it overheat.. good luck

Jul 02, 2009 | Saniflo & Saniplus& Macerator Pump

Not finding what you are looking for?
Hotpoint 24 in. HDA3400G Built-in Dishwasher Logo

Related Topics:

122 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hotpoint Dishwashers Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

yadayada
yadayada

Level 3 Expert

76846 Answers

Brad Brown

Level 3 Expert

16194 Answers

Are you a Hotpoint Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...