Question about Dual 2-Channel Bridgeable MOSFET Amplifier (XPA4100) Car Audio Amplifier

1 Answer

How to find the correct rotary encoder from my previous post.

Thank you very much for your help. I would have never figured that out haha. Only thing is, how can I find the exact one I need without having to take my broken one out and look at it?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 12 Answers
Re: how to find the correct rotary encoder from my...

Its not really a POT (Potentiometer) but a rotary knob, you can try radio shack or digi-key. if you can't find one, you can probably fix the one you have, you just have to open it up, clean it and re-adjsut the inside of it, be carefull becaus there are small parts that can easily brake.....

Posted on Jan 07, 2008

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

The light is red and no bass is coming out of my subs

The Amp Is Most Likely In Protection Mode... 2 Ways To Figure Out Whats Wrong With it Is Check Every Single Wire And Make Sure That Every thing Is Hooked Up Correct And There Are No Bad Connections With Ur Remote Wire, Ground Wire, And Battery 12v Wire, Rca Cables As Well. If Every Thing Checks Out Good Then Try Checking The Fuses And Make Sure u Are Using The Correct Fuses That Are Good For That Amp. If U try These 2 Things And You No Your Subs Are Hooked Up Correctly Then The Worst Is Probably There. I Had The Pioneer 7200 Amp And It was A Blown Amp And The Red Light was Constantly On. No Sound No Nothing. If U Try Those Steps And it Still Does Not Work Then Most likely Your Amplifier Is Toast. Hope This Helps :-)

Feb 18, 2011 | Kole audio Q2-1920 Car Audio Amplifier

1 Answer

Mtx ampnot working

Try disconnecting the power supply and ground completely and reconnecting it starting with the ground then power and then the remote lead- Ihad a kenwood that was picky like that and if you hooked it up in the wrong sequence it wouldnt go -but once i figured that out- i never had a problem with it again-till someone stole it-.haha good luck-why did you pull the fuse to bridge your amp?thats odd-any particular reason?

May 29, 2009 | Jl Audio E1200 Car Audio Amplifier

1 Answer

Protect light comes on when rca cables are hooked up

Make sure you have a correct ground. Grounds will have problems doing this. Connect to a bolt, but make sure it isnt a colored one. Also make sure your rca cables arnt neg and connected to a positive :) haha

Apr 13, 2009 | Lightning Audio Bolt B2.350.1 Car Audio...

1 Answer

Just bass through speakers attatched to amp

there is probably a switch that says lpf-full-hpf those are your low pass filter(only low tones) full which is all ranges of sound and high pass filter which when you want to hook up a set of mids or highs I hope that this helps u out

Apr 01, 2009 | Car Amplifiers

1 Answer

Behringer pmx 2000 missing knob

If the shaft broke, then you will have to replace the whole encoder for it. You cannot glue a shaft and expect it to hold.

Mar 17, 2009 | Behringer POWERED MIXER, 20 CH, 400 WTS...

1 Answer

Low Voltage Post

The head unit doesn't need to be replaced. It can be repaired if the shield is open.

If the amp still give an indication of low voltage and the voltage isn't too low, the amp probably has an internal fault.

Aug 17, 2008 | Alpine MRV-1507 Car Audio Amplifier

2 Answers

Dual head unit help!

You can try contacting the manufacturer to see if it can be repaired.

When you have this type of problem, it's generally due to the rotary encoder failing. It's unlikely anyone else will have parts.

Dec 22, 2007 | Dual 2-Channel Bridgeable MOSFET Amplifier...

2 Answers

Car Stereo Volume Goes Up and Down Erratically

prolly buy a truck and a amp from this century

Oct 05, 2007 | Car Amplifiers

2 Answers

Amp protection light

Hi again, Looks like you posted twice, in any case pls have a look at your other post @

Aug 15, 2007 | Sony XM-2002GTR Car Audio Amplifier

Not finding what you are looking for?
Dual 2-Channel Bridgeable MOSFET Amplifier (XPA4100) Car Audio Amplifier Logo

Related Topics:

51 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dual Car Amplifiers Experts

Neville Ward

Level 1 Expert

6 Answers

Tygh Duval
Tygh Duval

Level 2 Expert

290 Answers

Pablo Gonzalez

Level 3 Expert

733 Answers

Are you a Dual Car Amplifier Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides