Question about Car Audio & Video

1 Answer

Need help installing my x-plod xm-zr604 amp in my car and am not sure about how to hook up the speakers need wiring diagram

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 58 Answers

Http://www.the12volt.com/caraudio/woofer_configurations.asp
Go here and enter their specs, and it will tell you the ways to wire them. (Even though they say subwoofers, it works for speakers to.

Posted on Oct 24, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Amp xm-ZR604 keeps going into protect mode


check the ground and the positive wires to make sure that they are getting good continuity. if your amp is too small for the speakers you are pushing this will also put the amp into protect mode

Feb 09, 2011 | Sony - XM-ZR604 4/3 channel car amplifier

1 Answer

I have two sub woofer and when turned on to 16 to 18 volume the amp gets off...


its probably one of the below
going on protect mode as the amp cannot handle power
going on protect as voltage is dropping too low (upgrade wiring kit)
check if your amp is 2 ohm stable (if you have it paralelle on the same chanell)

Jan 07, 2011 | Sony - XM-ZR604 4/3 channel car amplifier

1 Answer

Need wire diagram koiiler xm 7676


U CAN GET ALL UR WIRE DIAGRAMS FROM PIONEER WEBSITE JUST OUT IN UR MODEL NUMBER THEN TYPE IN WIRE DIAGRAM

Feb 13, 2010 | Koiiler XM-7676W Car Audio Amplifier

1 Answer

I have a 04 silverado with factory bose stereo. I have installed a Xplod xm-zr604 and the sub is playing but it will not crank up. Its as if the volume is very low.I have tie in after the factory amp for...


If you dont have a line level converter with adjustable output - get one.

Your amplifier only amplifies the signal it gets - and if its a very low voltage - you wont get as much output from the ampifier.

I always recomend PAC converters. They are a little more expensive - but are #1 adjustable, and #2 they also make one with voltage sensing. You wire up a positive power source, and when it detects voltage from the speaker wires - it will send a remote turn on to your amplifier. (MTX has this technology built in to its amplifiers)

No more crawling under the dash or removing the factory radio!!!

Thanks for using FixYa - a very Helpful rating is appreciated for answering your FREE question.

Jul 23, 2009 | Sony Xplod XM-554ZR Car Audio Amplifier

5 Answers

Wiring Diagram for Sony car amplifier XM-554ZR


You can download the installation manual from the link below: http://www.sony.co.id/support/product/xm-554zr?site=hp_en_ID_i It has the following diagram plus other hookup info... Please update the question & let us know if the information given was useful to you - Good Luck!

Aug 14, 2007 | Sony XM-2150GSX Car Audio Amplifier

1 Answer

Sony XM-DS1300 amp


If they have bridged the outputs of the amp, be sure that the "ohms" load is 8 ohms. This would then apply a 4 ohm load to each of the output channels. It sounds like they have bridged the output or else hooked up the speakers in a paralled configuration that is trying to kill your amp. If you are using dual voice coil speakers then you have to treat each of the voice coils as a seperate 4 ohm speaker and wire accordingly. You need to correct this NOW or else you will fry your amp. Good luck.

Mar 03, 2007 | Sony XM-DS1300P5 Car Audio Amplifier

Not finding what you are looking for?
Car Audio & Video Logo

Related Topics:

128 people viewed this question

Ask a Question

Usually answered in minutes!

Top Car Audio & Video Experts

xxxxxx xxx

Level 3 Expert

4844 Answers

yadayada
yadayada

Level 3 Expert

75797 Answers

The Knight
The Knight

Level 3 Expert

74106 Answers

Are you a Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...