Question about GE Spectra JBP84 Electric Kitchen Range

1 Answer

JBP84TOHWW GE Electric Range Large Dual Element Not Working

Dual right front burner not working. Light comes on at knob but smooth top does not come on. All other elements in smooth top are operational.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers
Re: JBP84TOHWW GE Electric Range Large Dual Element Not...

Similar problem after a power outage. Display would be blank until I turned ON an element (after which display would light, but no power to the respective element. No elements would heat even thought the dial shows power). Turning OFF the element would blank the display. I reseated the power cord and cycled the 50a basement breaker for 5 mins. Everything now works, but not sure for how long.

Posted on Apr 11, 2010

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

I have KitcheAid KERS 807, electric stove/oven range. Left lower part of ceramic stove top that has single/dual heater sizes is malfunctioning. Single one is still working but from recent dual does not.I...

Either the knob has gone out or the burner element. I would test the knob first to see if there is current when turned to the large zone. If the knob is working, next would be to test the burner to see if the outer ring has burned out. I would guess more likely the control has gone out. Burners have less failure (typically).

Apr 14, 2014 | KitchenAid KERS807SSS Electric Kitchen...

1 Answer

Burner seems to be wired backwards

You have to access the underside of the cook top. Does the back right work correctly? If so switch the wires on the back left to match the right burner.

Jul 01, 2009 | Kitchen Ranges

1 Answer

Small burner of dual surface(right front) stopped working.

Does yours have the (small large burner switch)? If so, try switching it back and forth. It could be defective or your small burner element is bad.

Mar 11, 2009 | GE Spectra JBP78 Electric Kitchen Range

1 Answer

Kenmore glass top range left front large burner out

check the burner socket, it is likely that contact is being lost where the burner connects to the hardwired portion of the system (the socket). It is not unusual for the socket to "burn up" when there is a poor connection to the burner resulting in the burner being replaced and the new burner not working or working intermittently.

Please take the time to rate this solution

Jan 29, 2009 | Kenmore 95002 / 95004 Electric Kitchen...

3 Answers

Dual element burner on glasstop range...inner element stays on

It is the burner control (behind the knob). The triac in the control has failed. $50 item, 10 minute change. Just make note which wire goes to which terminal.

I doubt that it is the control board, as the board has little to do with the stove top, but rather controls the display and the oven temperature/feedback monitoring.

Hope this helps.

Jan 14, 2009 | Frigidaire FEF366DC Electric Kitchen Range

5 Answers

Replacing a radiant element on a maytag glass top range I'm having strange problems with the two right elements of my MER5770 The front larger dual element will only operate at high heat. When turning on...

If the burner is scorched or pitted, go ahead and replace it. New burners can cost anywhere from $10 to $40. Otherwise, check the burner's electrical connections to make sure there is solid contact. Jiggle the burner in its socket. If it is loose, then remove the burner—most just pull out of the electrical socket, although some are mounted with a screw. (Always unplug the range before removing a burner.) Slightly spread the two terminals apart for a tighter connection. If it still doesn't work, then replace the faulty burner with a functioning burner of the same size. If that burner works, then replace the bad burner with a new one. If it doesn't, then inspect the electrical socket for damage. If it's charred, replace the socket. To do so, remove the screws that secure the socket to the range and then unscrew the range wires. Attach the wire connections of the new socket to the range wires and reassemble the burner.

Aug 19, 2008 | Kitchen Ranges

1 Answer

Help in Removing Frigidaire Smooth Cooktop Burner

What holds the spring assembly onto the bar assembly is just two small prongs. Use a pliers on the end that protrudes through the bar, squeezing the prongs together, and it should come out fairly easily.

Oct 14, 2007 | Frigidaire FEF336BC Electric Kitchen Range

Not finding what you are looking for?

Open Questions:

See all GE Spectra JBP84 Electric Kitchen Range Questions

GE Spectra JBP84 Electric Kitchen Range Logo

Related Topics:

387 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kitchen Ranges Experts

Dan Webster
Dan Webster

Level 3 Expert

8147 Answers

Barrett Palumbo
Barrett Palumbo

Level 2 Expert

1772 Answers

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

Are you a Kitchen Range Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides