Question about Sony FD Trinitron WEGA KV-24FS120 24" TV

1 Answer

Sound My sound on my TV is garbled and after awhile it's ok and then it goes back to being garbled again. Any Ideas????

Posted by on

  • gospelfiddle Sep 12, 2008

    Need instructions on changing to alternate output

×

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

Your problem is a dirty filter in your audio resistance .. need to be clean the audio module ... or tring to change to other output will solve the problem

Posted on Dec 31, 2007

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Dlp hl t 5075s pops vol reduces ,comes back to normal volume pops randomly ,picture fine . sound is garbled weird sound . shut down for a few minutes then ok for awhile ??


Sounds like its audio output section circuit has the fault. Contact any service technician to troubleshoot. Check the speaker/s first. If found OK; check and replace the damaged component/s at its audio output section circuit board. If needy, replace this board as card basis. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts. Surf the site with patience.
http://electronicshelponline.blogspot.com/

Sep 10, 2014 | Televison & Video

1 Answer

JVC LT47 that picture goes black (sound fine) after being on for awhile. Can turn TV off, then back on & it's fine. But then happens again about ever hour or so.


Hello
Hello
It is due to some loose soldering points [dry soldering we say it technically], in the power supply section of the TV. Just check for it. Check the solderings of all components, that will heat up to an extent when the TV works on. Repeated heating and cooling may make solderings to the terminals of that components to get loose. Just resolder all the suspected solder terminals, by applying a little more solder, without making any solder bridge short in between adjecent solder terminals. This must solve the problem to your tV. OK.

Feb 11, 2012 | JVC Televison & Video

1 Answer

Dynex 32" tv picture goes black


If there is still about ? 24. Volts coming from the Power Board when it goes dark, it will be the Inverter board that needs replacing. If not, it is the Power Board that needs replacing. The Voltages should be written next to the sockets & plugs on the Power Board.

Jun 02, 2010 | Dynex 32 in. LCD Flat-Panel HDTV

1 Answer

Garbled sound as the system accesses something. Disk light pops up at same frequency as garbled sound appears. The Windows startup and shut down sound also is garbled. Using Windows XP on an ASUS K8V...


1. check the cable to the DVD or CD to the sound card it may not be connected properly.
2. remove the sound card from the motherboard and do "shutdown" then restart without the sound card.
3. Shutdown again reinstall the sound card and reinstall the drivers for the sound card.
4. check the the manufacturer website for any firmware upgrade drivers

Sep 21, 2009 | ASUS Computers & Internet

1 Answer

Magellan Maestro 4210 no audio or garbled sound


I suggest you take it back to the seloloer before the warranty expires

Jul 20, 2009 | Magellan Maestro 4210 Car GPS Receiver

1 Answer

Bad sound-garbled and goes off on certain channels.


Go into the menu and make sure the SAP is off.

Oct 24, 2008 | Sansui DTV2760 27" TV

1 Answer

Fisher , rear projection tv no picture got sound


Probably your bulb, replace it and you should be fine

Feb 07, 2008 | RCA P60921 60" Rear Projection Television

Not finding what you are looking for?
Sony FD Trinitron WEGA KV-24FS120 24" TV Logo

Related Topics:

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sony Televison & Video Experts

The Knight
The Knight

Level 3 Expert

75846 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Jerry Greenberg
Jerry Greenberg

Level 3 Expert

1689 Answers

Are you a Sony Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...