Question about Hotpoint RGB745 Gas Kitchen Range

1 Answer

Gas was turned off while I was out of town for summer. Gas Co. turned gas back on but top burners won't light up.

Posted by on

  • Fatih tademir
    Fatih tademir Nov 11, 2016

    tube burning wont. however before nice like burning. hardship where?


×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 120 Answers

They will require a cleaning of the tubes and orafices. Blow out with compressed air.

Posted on Oct 06, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Repairman can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Repairman (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Igniter glows but why doesn't burner light?


Igniter could still be faulty(not hot enough) or burner control valve
faulty. press the helpful button and check link videos below
Gas Stove Top Burners Not Lighting Not Working

Gas Stove Ignitor and Burner Not Lighting

Daddy Chores Gas range won ignite How to fix it


Jan 22, 2016 | Kitchen Ranges

1 Answer

Gas grill wont lite manuallly


Do you mean it won't match light or the ignitor won't spark and light the burners? Or both?

If it won't match light or the ignitor sparks, but the burners don't light, that means you're not getting gas to the burners.

Check to the tank valve and make sure it's turned ON. Also, make sure that there's gas in the tank.
If both of those check out as OK, turn the gas tank valve OFF. Disconnect the hose from the tank and wait 5 minutes. Reconnect the hose to the tank and turn the tank valve ON VERY, VERY SLOWLY (Slow motion, slow). Once the valve is fully open, light the burner farthest from the tank first and turn it to HIGH. Did the burner light and the flame height looks correct? If so, light the remaining burners following the same procedure. Now, are they all lit and the flames heights look correct? If so, you solve the problem. Just remember to always open the tank valve very, very slowly.

if the burners failed to light. Remove and clean all the burners, as well as the venturi valve on the open of each burner. Spiders like to build nest in the venturi valves.

if cleaning the burners did not solve the problem, you will need to replace the grill's hose/regulator assembly. You can find it in any home center or hardware store that sells gas grills and accessories, for about $30.00. Take you old one with you for comparison purposes.

Hope this helped you troubleshoot and solve the problem. Please be kind enough to let me know. Thanks and Happy grilling!!

Jun 10, 2011 | Weber SPIRIT E-210 (NG)

1 Answer

I have an endless summer 92000 table top propane heater. Lights fine, but the flame does not burn at the edge of the burner. Instead, it only burns in the very center of the burner... much like a Bunsen...


Actually, it's a gas pressure issue. But, it's fairly easy to solve. First, you need to be sure that your LP Tank has a sufficient amount of gas. If it does, turn the propane tank valve OFF. Disconnect the hose from the tank and wait 5 minutes. Then reconnect the hose to the tank and turn the valve ON VERY, VERY SLOWLY (Slow motion, slow). Once the valve is fully open, light the burner as you normally do and turn the burner flames to HIGH. Has the burner flame returned to normal? If so, you solved the problem. Just remember to always turn the tank valve ON very, very slowly.

If it didn't solve the problem, you will need to replace the heater's hose/regulator assembly. Generally, i's the same type that a gas grill uses. So, it won't be hard to find one.

Hope this helped to troubleshoot and solve your problem. Please let me know.

Apr 30, 2011 | Endless Summer 92000 Table Top Patio...

1 Answer

Burner will not light. With the pilot light burning and the gas is turned-on to ignight the main burner the pilot light goes out.


call aservice tech your pilot light might be blocked therefore the pilot flame might not be strong enough to handle the puff of gas when the gas valve opens ps. if the unit is off in the summer spiders are usually the problem. Hope this helps

Aug 19, 2010 | Endless Summer Heating & Cooling

1 Answer

Yokr gas furnace will not start up


You could have the gas co to check to preassures at or before the unit. Too low or high a preassure and the gas valve cant regulate the proper flow>>Natural gas to the house needs at least 5"-wc psi ---to the gas valve needs 7.5"--wc and while its calling for heat the orrifice needs 3.5" -wc psi! Propane needs 11" wc psi to the valve on the unit and 11' -wc psi to the inside furnace.

Dec 21, 2009 | Heating & Cooling

1 Answer

Where is the pilotlight on a ge xl44 gas stove I belive it is in the door under the oven well I turned the gas on and stuck a flame down there and nothen took off is there a certian place to put the flame....


In general lets be clear. The OVEN pilot is located under the oven door at the top of the Broiler.It is a small piece of metal just before the GAS safety Valve which acts on temperature so gas won't flow unless Pilot is lit,That's the OVEN PILOT.The stove's RANGE is the top burners where you heat Pots and Pans.It has either 2 Pilot lights that connect the burners to the Flame they are under the Range Top.Newer Models use electronic ignitions no flame.Please note if you had your stove/oven disconected or Gas off when you turn it back on there will be air in the line that needs to escape before you light.This is why in NYC when Utility Co.works on steet main the MUST re-light your appliances.Be Careful with Gas.Good Luck.

Sep 19, 2009 | Ovens

1 Answer

Problem with gas getting to the front burner


Follow manufacturer's recommendation in resetting the excess flow safety device....(Turn burners and LP cylinder off...Disconnect regulator on cylinder. Turn both knobs to high for at least one minute...Then turn them to off...reconnect the regulator to the LP tank...Turn LP valve VERY slowly (30 seconds) until fully opened..then start the grill in the usual manner. ALWAYS TURN THE LP TANK OFF WHEN DONE USING THE GRILL....

Jul 04, 2009 | Weber Genesis Silver B Grill

1 Answer

Propane patio heater ignition problem


I would change the thermocouple and here is why:

The thermocouple is the pilot's, well, co-pilot! It is the electronic device that senses if the pilot flame is hot enough to sustain burning the gas fuel from the burner. If the thermocouple thinks it's safe, then it keeps open the main gas valve located in the pilot assembly. If the thermocouple does not sense enough heat from the pilot flame (such as when the pilot is out), then the thermocouple shuts off the gas valve to the burners.
How the Thermocouple Works
So what is this thing and how does it work? Well the thermocouple (technically called a thermocouple junction) is a device that contains two metal wires welded at the ends and placed inside a protective metal case. The thermocouple sensor is found at the business end of the pilot flame and is designed to be placed in the hottest part of the flame. The other end is connected to the pilot valve body. As the thermocouple heats up, it produces a small amount of electricity and when it gets hot enough from the pilot, send a signal to open the gas valve by using a solenoid operated by a 24 volt transformer. The thermocouple calls the shots, and by converting heat to an electrical signal, it allows the gas valve to open or close. Once the gas valve is open, gas is then constantly supplied to the pilot and as required for the gas burners (as called for by the thermostat). If the pilot goes out, then the thermocouple gets cold and produces no electric signal to open the gas valve's solenoid and the gas valve shuts off the gas supply to the pilot and burners

May 27, 2009 | Endless Summer Blue Rhino 235000...

3 Answers

Ge spectra gas stove top not lighting


If your top burners are not lighting or will not work, it is possible that the burners have become dirty or wet. Please follow the troubleshooting directions below before calling service:
  1. Turn you burner to the Lite position:

    If you hear clicking or sparking, go to Step 2.

    If you do not, check your circuit breakers. If the circuit breaker is ok, we recommend that you schedule service by calling 1-800-432-2737 or schedule service online.

  2. Clean the burner and electrode:

    First remove the burner grate, cap, and head. Use a needle or paper clip to poke through the holes on the burner head. Re-assemble and try the burner.

    Remove the burner grate, cap, and head. Even if it looks clean, wipe the tip of the electrode with a clean, dry paper towel and PRESS IT DOWN. Re-assemble and try the burner, again.

    Check to see if the burner works, If not, then go to Step 3.

  3. Re-assemble - Make sure that each burner top matches its burner bottom. The burner top will lay flat if put on correctly.

    Check to see if the burner works, If not, then go to Step 4.

  4. The spark igniter is operating properly, but the burner is still not lighting. At this point, we would recommend that you schedule service by calling 1-800-432-2737 or schedule service online.

Aug 15, 2008 | GE Profile Spectra JGBP90 Gas Kitchen...

1 Answer

We bought our grill last summer and it worked fine. When we got it out of the garage this summer and replaced the gas, it wouldn't start. We can smell the gas so we know it is reaching the burners.


this sounds like an ignitor problem to me. You could replace the ignitor or you could light with a match. Most of these grills have an access point usually on the right side to light the burners with a match just make sure you light the match first and hold it into the access point before you turn the gas on.

Jun 20, 2008 | Char-Broil CharBroil 4637318 Grill

Not finding what you are looking for?
Hotpoint RGB745 Gas Kitchen Range Logo

Related Topics:

86 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hotpoint Kitchen Ranges Experts

Dan Webster
Dan Webster

Level 3 Expert

8220 Answers

Ismael Rodriguez...

Level 2 Expert

171 Answers

Justin Duby
Justin Duby

Level 2 Expert

370 Answers

Are you a Hotpoint Kitchen Range Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...