Question about Dishwashers

2 Answers

Dishwasher not draining

Water standing up in bottom of dishwasher after cleaning not draining water left standing after cleaning and drying cycle A brand new dishwasher it is not finishing its cycle, and the water is not draining.

Posted by on

  • 11 more comments 
  • kimpfeifer Jan 19, 2008

    water is not draining and is left at the bottom after the full cycle. Dishes are dirty and so is the water. Already checked for food blockage. Please help.

  • Anonymous Feb 24, 2008

    inch of water left in bottom of dishwasher

  • Anonymous Mar 01, 2008

    Water is not going down and it also leaks.

  • Anonymous Apr 04, 2008

    I have a brand new dishwasher that does not drain, Help............

  • stevensx Apr 24, 2008

    my new diahwasher worked fine for a couple months then stoped draining the water. ibought a new dishwasher it worked a couple times am having same problem again?

  • Anonymous Apr 25, 2008

    water standing up in bottom of dishwasher after cleaning not draining
    water left standing after cleaning and drying cycle
    A brand new dishwasher it is not finishing its cycle, and the water is not draining.

  • Anonymous Apr 29, 2008

    I have a dishwasher that I have owned for two years. The dishwasher is not hooked into a garbage disposal. A couple of days ago the dishwasher stopped draining. It washes the dishes and drys them but will not drain the water. I took the inside apart and cleaned all then ran the dishwasher again...it is still not draining and not sure what else to do.

  • sejh May 10, 2008

    ge dishwasher that has water standing in the bottom

  • Anonymous Feb 15, 2009

    standing water in bottom of washer after cycle

  • Anonymous Mar 18, 2014

    195 water will not drain water lay in bottom

  • Anonymous Mar 20, 2014

    I have removed and cleaned the filter and debris from the bottom of the machine.

  • Anonymous Mar 20, 2014

    Water still standing in the bottom when dishwasher shut off

  • Anonymous Mar 31, 2014

    I cleaned out the strainer at the rear (which needed the cleaning) as well as the one in the bottom, though it had no apparent obstruction, just gunk that's been sitting in the bottom.

×

Ad

2 Answers

You may find that there are utensils or small objects falling into the water - the sensors pick that up and won't drain

Posted on Jun 01, 2008

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 126 Answers

If its new call your dealer its a warranty call

Posted on Dec 22, 2007

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

aborcass
  • 2651 Answers

SOURCE: dishwasher not draining

try pressing the cancel/drain button.Do you hear water draining into sink freely?? if not i would disconnect drain undersink look for a clog right there first

Posted on Feb 22, 2008

  • 17 Answers

SOURCE: dishwasher not draining

So it sounds to me like it is your "pump" I work for an appliance parts dealer and it looks to me like the pump you need is originally part# 99002750 but then it changes to #6-917641....It runs about $57.00 and you can find this product at www.allbrandonline.com
Hope this helps!
www.appliancepartsonline.net

Posted on Feb 16, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why is there water standing in the bottom of my dishwasher after it has completed the wash and dry cycles.......


If water remains in the dishwasher after the cycles end, check the kitchen sink drain to make sure it's not clogged. If there's no clog, try pressing the Cancel button; most dishwashers run the drain pump when the Cancel button is pressed.
Check the dishwasher drain line, drain path and drain pump.
1396454190772-ic2agsuhdt5a3e2mib5hbxs3-4-0.jpg

Oct 25, 2017 | Dishwashers

1 Answer

Is this normal for Miele dishwasher? - some water left below filter and not everything dry after cycle


Plastic items do not get dry because they do not get as hot as glassware. A lot of moisture inside is do to the evaporation of water on the dishes during the dry cycle. Some water remains in the dishwasher because it is impossible to pump all of it out. There is nothing wrong with your dishwasher.

Oct 31, 2015 | Miele Dishwashers

1 Answer

GE dishwasher PDWT480R10SS does not fully drain at end of cycle


you need to clean the outside edge of the disk at the bottom of washer and put high heat silicone around the outside edge and let it dry 24 hours before use, if it still doesn't drain all the way ,you will have to replace the disk. I have repaired many of these . good silicon should do it.

Sep 14, 2014 | GE Dishwashers

1 Answer

The top drawer of my FP dishwasher is not cleaning everything properly. The glasses or dishes in the front left side are always dirty and are covered with crumby dried residue when the cycle is complete....


Hi

If you are noticing that the dishes are not clean, then there are a few things to check for. Check the soap powder if it's kept in a dry environment. Also try replacing the powder with something like a gel or liquid. Next thing to check for is the water pressure and fill valve. Check if the water is filling in and the spray arms are throwing the water with enough pressure. Try and listen to the sound if you hear a proper spraying action sound.

If it seems as a low water pressure then check the fill valve. Now, check if dishwasher is draining the water or not. While the dishwasher is working check whether the dishwasher is draining and there is not much left out water after the cycle is complete. Try cleaning the spray arm with a soft brush. The water temperature plays a major role in cleaning of dishes. The temp should be between 125 and 150 F for dishwasher to clean the dishes. Hope this helps...

Feb 20, 2011 | Fisher and Paykel 23 in. DD603H SS...

2 Answers

I have a brand new whirlpool DU1055XTV5 dishwasher, installed two days ago. After the cycle completes there is about 1/2" clean standing water left in the bottom. It is not just down in the well area,...


Ensure the outlet pipe is below the level of your floor and straight to a drain or plumbed into the waste pipe directly with no chance of syphoning from standing water in your drain/waste pipe.

Apr 04, 2017 | Whirlpool DU1055XTS Built-in Dishwasher

1 Answer

Miele Dishwasher G841 - Water not draining after wash cycle


If you suspect the dish washer, try discharging the drain in a bucket. After the drain cycle check the wash tub. If water is still left, you have to clean the drain filter attached to the bottom. Refer user guide.

The final drain end of the dish washer where you discharge, the fixing junction has to be cleaned, incase it is clogged.

Jun 01, 2010 | Miele 24 in. Touchtronic Platinum Built-in...

1 Answer

Water didn't drain, left in bottom of washer tub


I had similar problem and it ended up being a clog at the point where the drain hose meets the garbage disposal. I had to unhook the hose and clean out the food that had accumulated (horrible smell). You may have to stick a screwdriver into the garbage disposal hole where the hose fits and clean the food out there also. Then put the hose into a bucket and run a few cycles to ensure the hose is free.

Aug 01, 2009 | GE Nautilus 24" Built-in Dishwasher

1 Answer

Doesn't drain after "normal cycle" is run


It does sound like you have a switch problem or like the knob is simply getting stuck. Try taking it off and cleaning it if possible. Most common hardware problems with draining you have water at the bottom and it will not drain no matter what untill you clean the drain hose or a valve. Good news is that it doesn't sound like an expensive fix. Good luck.

Jul 14, 2009 | Whirlpool 24 in. DP840SWP Free-standing...

1 Answer

Dishwasher not draining


try pressing the cancel/drain button.Do you hear water draining into sink freely?? if not i would disconnect drain undersink look for a clog right there first

Feb 22, 2008 | Kenmore 24 in. 17482 / 17484 / 17489...

Not finding what you are looking for?
Dishwashers Logo

Related Topics:

1,616 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dishwashers Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Marvin
Marvin

Level 3 Expert

83054 Answers

Brad Brown

Level 3 Expert

17490 Answers

Are you a Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...