Question about Televison & Video

1 Answer

Sirs, I plugged in my TV this morning after watching it last night and there is nothing. Tried resetting and pulling the plug and putting it back in. I hear a click (like you get when you get when you turn it on but nothing) Tried resetting it with the service reset but no good. Nothing on the screen. Changed inputs still no good. I have it hooked in to direct TV and Cable. Before I open up the back I wanted to know what I should look for. Probably bad news. But I want to try everything before I junk it. (13 years old) Is there any hope? Dan Studzinski

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 448 Answers

The issue may be related to the projection lamp if sound is coming but picture. However, if the sound and pictures, none of them is coming then the issue is with the optical block or light engine that houses every other components.

Posted on Oct 05, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Hitecker 32 inch TV suddenly will not show any inputs other than TV. Worked fine last night. Doesn't this morning. No power surges that are known about overnight.


Fault with its main board. Short circuited component/s at it. Contact any service technician; or the authorized service center. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts. http://electronicshelponline.blogspot.com/ . In most cases, the main board might have to be replaced. If so, a software [firmware] update too might be necessary.

Nov 01, 2014 | Televison & Video

1 Answer

Sony KL-50W2U rear projection TV stuck in standby


Try holding down the power button until it turns off and then turn it on again.

Nov 29, 2012 | Sony KL-50W2U

1 Answer

I have a 52"


Need model number and blink code at time of defect.

Feb 16, 2011 | Panasonic Televison & Video

1 Answer

Last night I was watching TV just fine. I turned off the TV when I went to bed and then tried to turn it back on this morning when I got up. It wont turn back on and I have checked to make sure that there...


Check ur power source?Tries tv unplug,replug the tv back like about an hour later.Now the tv are resetting it self back to the factory setting.The tv should work now.If still have the same problems,some how ur power supply board is causes and is not providing the tv the wright voltages anymore.That the board,where the power a/c cord plug into it.Tries websites like Shopjimmy.com,Ebay.com to buy a whole refurbish power supply board for the replacement.

Dec 09, 2010 | Mitsubishi LT-40133 40 in. LCD HDTV

1 Answer

Mitsubishi WD-52525 was working fine and now it will not turn on


This is just a shot - but it worked with my Sony (same problem).
Pressed remote power on button AND held Power button on TV on at the same time.

Set clicked 4 or 5 times and then came on....

Other, most have a (VERY small) reset switch on the rear - near where the power cord enters the TV... Use a flashlight and a mirror to locate it on your set....

Nov 26, 2009 | Mitsubishi WD-52525 52" Rear Projection...

2 Answers

Power light on, nothing happens


Try holding down the power button for several seconds. This will shut down the PC. You should then be able to reboot the system.

Sep 10, 2009 | Toshiba Satellite A135-S4527 Notebook

1 Answer

Tv won't turn on


I had a similar problem when there was a power outage or the lights went briefly out. I unplugged the TV and left it for a few days/weeks and then plugged it in and the TV worked. I think newer TVs should be treated like a home computer and put them on surge protectors.

Jul 08, 2008 | Televison & Video

1 Answer

Part of [icture missing


Brand name & model number would be helpful.

Have you tried reset or re-boot by unplugging the ac cord

for awhile,then plug back in,try again?

Is it under warranty or did you receive it second-hand??

Let me know....T.

Oct 19, 2007 | Televison & Video

3 Answers

No picture, sound and flashing red power light...


Pull off the back pressboard. At the bottom left hand corner is the power cord that attaches to the power supply board. There is a white plug that attaches directly to the power cord. With the TV power off, pull this white plug up to disconnect. Then push it back in. Then plug your TV back in and press the power button on the front of the TV. I just did this and it is working fine.

Sep 16, 2007 | Toshiba TP43H60 43" Television

Not finding what you are looking for?
Televison & Video Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Televison & Video Experts

The Knight
The Knight

Level 3 Expert

73691 Answers

Cindy Wells

Level 3 Expert

5060 Answers

Electro Med Services...
Electro Med Services...

Level 3 Expert

6694 Answers

Are you a Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...