Question about Hotpoint Aquarius WD640 Front Load Washer/Dryer

1 Answer

WD420 Aquarius Washer Dryer

My washer dryer door seal has become rather smelly and distasteful leading to smelly washing, how do you change the door seal? please

many thanks

Andy Mellor

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert who has written 50 answers of more than 400 characters.


    An expert who has answered 200 questions.

  • Expert
  • 244 Answers
Re: WD420 Aquarius Washer Dryer

Easiest way is to take complete front off easier to get to m8 what u do is take lid off now turn your timer dial until u c a screw as u look down from above now pull soap drawer out undue screws behind it front panel will now come off now open the door undue undue the screws behind he kick strip at the bottom of the washer and the 1s at the top which u can c since u took the front panel of now take the clip of which goes around the door seal edge once uve taken this of u can pull the door seal away from the body this should let the main front panel come away u can now c how to take the seal of reverse when your ready to put it back together havea advised this way b4 and its the esiest way to do if u dont know what to do have had good comments about doing it this way m8

Posted on Dec 23, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Where is the filter on a Hotpoint Aquarius wd420 washer dryer?

it is located at the back of the machine...are you encountering problems with this machine? check this link i will give you, this a forum/comments which the owners encountered different problems with this machine..

Nov 13, 2010 | Hotpoint Ariston Aquarius WD420 Front Load...

1 Answer

My aqurius WD420 shows that the door is locked. So i can't open it........

If the door will not open normally, then the only solution is to remove the top cover, and force the door open from inside the washer at the front

Jan 17, 2010 | Hotpoint Ariston Aquarius WD420 Front Load...

1 Answer

My hotpoint wd420 is leaking water from out the dispensor and door on a rinse/spin cycle.

You ne to get yure rubber seals checked and changed it sounds like they have perished

Nov 27, 2009 | Hotpoint Ariston Aquarius WD420 Front Load...

1 Answer

Hotpoint Aquarius waher dryer

possible blockage ' filter or could aslo be water coming back from the sink if drain hose too low , you may need to raise this....

Nov 13, 2009 | Hotpoint Ariston Aquarius WD420 Front Load...

2 Answers

How do I remove and then replace a new door seal on my hotpoint WD420 washer / dryer

First switch off electrics , Remove door interlock , leave wires on .remove soap dispenser,remove front panel with controls 3 screws top of machine 3 screws bottom remove front casing you can now see door boot. remove sring note how boot came off refit is oposit to this noting top / bottom of seal ..Hope this some help-

Oct 03, 2009 | Hotpoint Ariston Aquarius WD420 Front Load...

1 Answer

Door seal needs to be replaced

For most front-loaders:
Plug off the wall mains. Remove the plastic clamp holding the seal to cabinet & peel off the cabinet. Push downwards on the seal close to the tub & the seal will come off - it's just held by a spring on the periphery.
Lubricate the slot which fits over the tub with washing-up fluid. Starting at the top, press the seal so the flange of the tub enters the slot on the seal. Work your way round the using thumbs to force the slot on the tub flange. When slot is on the flange all way round, fit the spring which holds it on. The spring goes into a slot on the outside of the seal. This is quite difficult and you may need another pair of hands. Fit the outside of the seal to the cabinet - this is easy and fit the plastic clamping ring.
Test for leaks before using. Use rinse to test as the water level is higher.
(There is no glue anywhere, only clamps,etc)

Pl rate me nice for the free help!

Apr 27, 2009 | Hotpoint Ariston Aquarius WD420 Front Load...

1 Answer

Turn washer dryer on ok, then close door then curcuit trips

check the wiring and make sure nothing metal is on the motor because your dryer has a short in it somewhere

Dec 23, 2008 | Hotpoint Ariston Aquarius WD420 Front Load...

1 Answer

Removal of door seal on hotpoint washer drier wd420

You will achieve nothing by removing the door seal .
Depending what is in there, better to leave alone and trust it will find its way into the filter.
If it is anything substantial then it involves major work.

Dec 14, 2008 | Hotpoint Aquarius WD640 Front Load...

Not finding what you are looking for?
Hotpoint Aquarius WD640 Front Load Washer/Dryer Logo

157 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hotpoint Washing Machines Experts


Level 1 Expert

5 Answers


Level 1 Expert

47 Answers


Level 3 Expert

2963 Answers

Are you a Hotpoint Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides