Question about Philips LX3000D System

1 Answer

My DVD player no longer plays original dvd's - only copied dvd's

I am inserting an original DVD into my DVD player and you can hear it trying to read it but after a few minutes it displays "No Disc". I then put a copied DVD into the player and it plays this immediately. Why is this the case and any suggestions on how to overcome this??

Posted by on

  • 2 more comments 
  • natty bubs Dec 22, 2007

    Hi Shanth,



    Thanks foy your comment but my problem is not with the burnt DVD's - they are playing OK. My problem is with original DVD's - they are not working. I borrowed a DVD from a friend who purchased it in Indonesia and this problem has occured since then. I went in the other day and changed the region code back to all regions but it still does not allow me to play all my original DVD's, only burnt/copied DVD's.

  • michael6240 Aug 18, 2008

    my philips LX3000D also no longer plays new discs, I have never put a "pirate" dvd on the system. It still plays some dvds that we have had for years but never brand new ones. Very annoying. Does anyone know if it is poss to just replace the actual dvd player as everything else sub, speakers etc all fine ?

  • Anonymous Oct 07, 2008

    We also have the problem of our dvd playing older dvd and ones we have recorded ourselves, but find a lot of new dvds jump or skip around, but only during the middle part of the film!

  • Zarathrousta Jan 24, 2009

    I have a similar problem with my LX3000D. It displays a 'No disc' message when I inserting a CD but plays DVDs without any problem.

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Vice President:

    An expert whose answer gotĀ voted for 100 times.

    Sniper:

    An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

  • Expert
  • 108 Answers

Some times when you create DVD movies by high speed DVD writers, your data cannot be read by dvd player with high performance. it s due to speed mismatching. always write DVDs with Normal speed in order to use with DVD players. while in case oof PC-DVD -Rom it does not happens. it can read any high speed wriiten DVDs. DVD-Rom in PC are more precise than DVD players. Some times Weak DVD player Lens system can also mis read.

Posted on Dec 22, 2007

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Dvd player reads "no disc" when I put disc in


Are the discs copy's or originals if there copy's some systems will not read them, if there originals then clean disc on laser eye with a cleaner disc

Mar 07, 2014 | Sony BDP-S350 Blu-ray Disc / DVD Player,...

1 Answer

Player reads DVD as bad


Are you using the correct format disc.If you are playing a blu ray disc in a non blu ray player the player will not read the disc

Jan 02, 2018 | Durabrand Audio Players & Recorders

1 Answer

Everytime I put a disc in I get an error saying no disc


Does the disc you insert are original..If not is isn't posibbles for your dvd player to not recognize yor disc cause most of the branded dvd players like you have didn't read pirated disc..but if the disc you insert is original. Try to clean your dvd player using a dvd disc cleaner.

Jul 17, 2011 | Philips DVP5982

1 Answer

Can't Read Disc


You could try updating the firmware.

Jul 06, 2010 | Philips DVP5990 DVD Player

1 Answer

Panasonic PV-20DF64 20 inch TV/DVD Combo TV can not read disc


If the disc loads up and you can hear it spin, then you get the error, more than likely the optical lens has been damaged. This will have to be repaired by a local shop if its worth the cost. if the part is available it would probably run anywhere from 130-165 to repair

Good Luck!
Ruben

Jul 23, 2009 | Panasonic PV-20DF64 20 in. TV/DVD Combo

1 Answer

RCA DRC 8052NB will not read discs


This sound like a problem with the laser read circuits and it may be solved with a simple cleaning and using compressed air to clear the unit of debris .To do this you must take off the top cover of your unit by taking out the screws and lifting the top off. To clean the laser head you should use cotton swabs and isopropyl alcohol. put a small amount on the cotton swab and rub the swab gently back and forth over the head, until it seems bright and shiny.Check the transport carriage for dust and debris and also the gears. all these must be clean for proper operation. You may want to put a little lithium grease on the gears and guide rails for smooth operation. All this should be done in minute amounts so you do not over do it and cause more problems. If all this fails to allow you to use you disc player, Then you probably have a worn out laser sensor and will have to have it replaced. If under warranty send it in and if not try to find the part number and order it and either take in to a service center for repairs or do it yourself. Hope this helps you with your problem.

May 15, 2009 | RCA DRC8052N DVD Recorder

1 Answer

My NAD cd/dvd T550 displays NO DISC.


I have the same problem. When I insert a disk, my NAD T 550 DVD player displays 'No Disc'. It started with new disks while still reading older disks, but at some time it stopped recognizing any disk. Did you receive any suggestion yet or has anyone a suggestion?

Jan 27, 2009 | NAD T550 DVD Player

1 Answer

DVD player cannot read DVD disc.


Have you tried other DVD's in this unit and they work? If so it might be just an incompatibility issue with that DVD in your TV.

Nov 16, 2008 | Panasonic PV-DF2004 20 in. TV/VCR/DVD...

1 Answer

Player Does not play any type of Disc


Press case lid where it attaches to player. If this makes unit react you have a defective lid switch. You can probably put some weight over it to hold lid down and it will operate. Otherwise switch must be repaired

Oct 06, 2007 | Jwin JD-VD149 DVD Player

2 Answers

My DVD player wont read a disc


There are several things you can do to try and solve your problem: Make sure that the DVDs you try to play are encoded for the right region. Make sure that the transportation lock (usually a plastic screw on the bottom of the unit), is not engaged. Turn off player with disc inserted, unplug temporarily from wall outlet, plug back in and turn back on.

Mar 20, 2006 | Panasonic DVD-S31S DVD Player

Not finding what you are looking for?
Philips LX3000D System Logo

Related Topics:

505 people viewed this question

Ask a Question

Usually answered in minutes!

Top Philips Audio Players & Recorders Experts

Gyula Lacz

Level 3 Expert

486 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

 Grubhead
Grubhead

Level 3 Expert

5585 Answers

Are you a Philips Audio Player and Recorder Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...