Question about DFI LANParty UT RDX200 CF-DR Motherboard
GO IN THE BIOS AND SEE IF THE SATA PORT YOU USING IS UNLOCKET BECAUSE SOME MANUFACTORYES SEND THE BIOS SET TO RECOGNISE THE SATA 1 AND 2 ONLY BY DEFAULT
Posted on Oct 04, 2009
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Tips for a great answer:
May 24, 2012 | DFI LanParty UT 915P-T12 Motherboard
One bad lead can cause a computer to continue on a cycle or
to shutdown or fail to detect your hard drive
Test all leads that attach to your hard drive including electrical
the leads from your
"((motherboard to your hard drive))" make sure they have a secure connection and are not faulty or
just replace them they could be faulty
make sure all leads that are attached to your drives dvd\cd 3 1/2 inch floppy have secure connections and are not faulty even the electical extensions or just replace them they could be faulty a computer needs its connections to continue its cycle and have an end so any faulty leads will end up with a computer error another possibility
Restart your computer with the XP Setup disk in the CDROM drive. If you are prompted to press a key to start the computer from CDROM, do so quickly. Otherwise it may try to boot from the hard drive. After a few minutes, you'll see a prompt to press the R key to start the Recovery Console. When Recovery Console starts, it will prompt you to enter a number corresponding to the Windows XP installation that you need to repair. In most cases, you'll enter "1" (which will be the only choice). If you press ENTER without typing a number, Recovery Console will quit and restart your computer. Enter your Administrator password. If you don't enter the correct password, you cannot continue. At the Recovery Console command prompt, type fixmbr and then verify that you want to proceed. Your damaged MBR will be replaced with a shiny new one, and you should then be able to boot your system normally. In some cases, you may need to repair the boot sector in addition to the MBR. If your system still doesn't boot properly, repeat the steps above, but issue the fixboot command instead. Hope this helps
Apr 26, 2011 | DFI LANPARTY DK 790FXB-M2RSH Motherboard
Jul 24, 2010 | Samsung SpeedPlus DVD-Writer 20x, Black ...
Jun 07, 2010 | DFI LANParty UT RDX200 CF-DR Motherboard
Jan 27, 2010 | DFI LanParty Pro 875b (LP PRO 875B)...
Jan 23, 2010 | DFI LANParty UT RDX200 CF-DR Motherboard
Jun 20, 2009 | DFI LanParty UT nF4-D Motherboard
247 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: