Question about Briggs & Stratton Garden

1 Answer

Oil to gas mixture for a craftsman 3.75 hp pressure washer

Oil to gas mixture for a craftsman 3.75 hp power washer 'clean and carry'

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

There is universal 2 cycle oil available (pro-mix at Lowe's for example) that is good for all ratios from 16:1 to 50:1. With this oil you add the same amount of oil to the gas independent of ratio required. One gas can, no ratio worries. Hope this helps.

Posted on Oct 03, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Repairman can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Repairman (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is fuel mixture on 25 cc craftsman weedwacker


This small engine needs a 40:1 ratio. Use only 2 cycle oil, not motor oil. If you are mixing one gallon of fuel use 3.2 ounces of the 2 cycle oil. This should give correct mixture so you do not get lots of smoke when you start. Take the time to measure. Note: there should be a marking somewhere on the engine about the mixture.

Sep 21, 2014 | Craftsman Convertible 25cc Curved Shaft...

1 Answer

Engine on powerwasher starts but quits running after approx 10 seconds. Engine oil changed, oil is full & tried choke in various positions. Also has fresh fuel in tank. What else can I do


try cleaning the carb that ethanol plays havoc on these small engines if it is not a premix oil and gas unit add a little 2 cycle engine oil to the gas will keep the carbon builup to a minimum not to much it will gunk up your spark plug take the carb apart and clean it with carb cleaner or deisellet dry check your spark plug make sure it is clean and ok that is where I would start

Jun 27, 2011 | Craftsman 2700 PSI Briggs Stratton...

1 Answer

Started by Craftsman 2700 PSI , 2.3 GPM Briggs & Stratton Powered Pressure Washer for first time in 9 months. Added new oil, and gas. started but is smoking from muffler and is dripping what appears to...


The first thing I would check would be the oil level, to make sure you didn't put in too much oil. If the oil level is correct, it could be a stuck piston ring, letting oil blow by the piston, and out the exhaust. If this is the case, you are going to have to tear down the engine.

Hope this helps!

May 09, 2011 | Craftsman 2700 PSI,2.3 GPM Briggs &...

1 Answer

Have a honda 5.0 hp engine on a pressure washer model belive is a de 1504 not sure of make, starts if you use starting fluid but then dies, getting gas to the bowl at botttom of carb but not to carburator


Hi there mburns44 i believe your problem is either that either the Air/Fuel mixture is too rich and causing it to flood or you have clogged jets. carburators are tricky and often times need to be cleaned or adjusted by a professional. I hope that this helps :)

Mar 30, 2011 | Devilbliss DeVILBISS Devap DVH2600...

1 Answer

I would like to know if this pressure wahser use only gas or (Gas and Oil) is mixed?


352edb9.jpg

If your engine has a place to put oil, then your power washer uses ordinary gasoline.
The only type engine that uses 2-cycle oil and gas mixture is engine that has no place to put oil.

Oil for pump comes half way up >>> pump uses SAE20 or SAE 30 non-detergent motor oil
Oil for engine comes half way up dip stick and uses 10-W30 motor oil

Oct 15, 2010 | Dewalt DPD3300 Commercial Pressure Washer

2 Answers

I have briggs and stratton powered mower with the 18.5 v-twin ohv intek engine modle 407777 type 0121-E5 CODE 000512ZYG MY PROBLEM IS THAT MY CRANKCASE IS FULL OFA GAS OIL MIXTURE THE OIL FILTER ALSO...


When the float in the carb sticks, it allows fuel to drain into the cylinder, that runs pass the rings into the crankcase. When the crankcase is full the pistons cannot go down, and the starter won't turn the engine. Drain all the oil gas mixture, and refill with proper oil. Replace float, needle and seat in the carb bowl. Throughly clean fuel passages, and bowl. If motor won't turn, remove spark plug and turn over engine a few times to remove gas oil mixture from the cylinder too.

Oct 02, 2010 | Craftsman 42" Briggs Stratton 20 hp Gas...

1 Answer

Can i use any 2 stroke oil


An electric chainsaw does not require 2 stroke oil. This oil is only used for gas/oil mixtures for gas powered chainsaw. Chain oil should be used (or even transmission oil) to lubricate the chain.

Aug 20, 2010 | McCulloch 16 In 4.5 Hp Electric Chainsaw...

2 Answers

How much oil in pump...Craftsman 2200 PSI pressure washer


Hello:
Best to use NON DETERGENT 10W30. Be sure you fill the reservoir only 1/3 to less than 1/2 full.

Aug 25, 2009 | Briggs & Stratton Garden

1 Answer

Gas Oil Mixture


Fuel Mix: Add 6 oz. McCulloch custom lubricant or 1 PT. S.A.E. 40 (16:1) to 2 U.S. Gal. Regular Gas

Aug 25, 2009 | McCulloch 16 In 4.5 Hp Electric Chainsaw...

Not finding what you are looking for?
Garden Logo

Related Topics:

890 people viewed this question

Ask a Question

Usually answered in minutes!

Top Briggs & Stratton Garden Experts

Phil Walker
Phil Walker

Level 3 Expert

608 Answers

John Trevino

Level 3 Expert

1388 Answers

donald boissonneault

Level 2 Expert

110 Answers

Are you a Briggs & Stratton Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...