Question about Fuji FinePix S700 Digital Camera

1 Answer

Every time I turn the camera on, the error message, "ZOOM ERROR" appears and it will not let me take any pictures. It will not move away from the screen with the error message. How do I fix this setting and get back to the normal setting?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 6,831 Answers

Hello

The problem is that the lens has become stuck in the barrel. There are some DIY solutions you could try, but the probability is that you will have to get it fixed by a professional.

Use these at own risk as it may further damage the camera.

Firstly , try connecting your ac adapter or usb cable.

Try holding the shutter button while switching on the camera.

Look at the lens , and if some of the lens 'circles' is misaligned or not concentric then try wiggling it (while holding camera lens down).

Try gently pushing or pulling the lens when it extends but this is risky as it may cause the lens barrel to slip out of its guidance system.

Another way to do this is to place the camera lens down on a hard surface and then power it up. Be sure to use a soft cloth or something similar as to not scratch your lens or casing. Let the lens push the camera up and down a few times and sometimes the little resistance provided by the camera is enough to get things going again.

Try hitting your camera near the lens on the body with the soft tissue on the palm of your hand.

Other than that , I would take the camera to a repair center for a evaluation to see if it would cost more to repair than to replace the camera.

If it is still under warranty I would suggest you take it in before trying any of these steps and remove any off-brand batteries or accessories as some stores are really fussy about warranty repairs on camera's with non-brand accessories.

You can also have a look at THIS link.

Hope the advise is useful. please do not hesitate to let me know if you need any further assistance. Also, please be so kind to let me know if you found this helpful.

Regards
Andrea

Posted on Nov 21, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

DSC W80 Error Message - Zoom and Picture Doesn't work


There is something blocking the sensors for the lens position. This can something as small as a piece of sand. The motors and gears that move the lens are very small and delicate. You can send it in for repairs to www.unitedcamera.com

Nov 24, 2013 | Sony Cybershot DSCW80 7.2MP Digital Camera...

1 Answer

Won't take pictures when zoom


Hi,
Most common problem in al the digital camera's. Slide motor start malfunction and the massage appears"Turn off the power and on again". In this situation you have to replace slide motor or lens block assembly, And your camera work fine again.
Thanks for using fixya.

Jun 27, 2009 | Sony Cyber-shot DSC-W80 Digital Camera

3 Answers

Fuji Zoom Error Message


drop it on the floor from a few feet I did this and now mine works

Aug 02, 2008 | Fuji FinePix A820 Digital Camera

6 Answers

Fuji Finepix Z1 Zoom Error


I saw another post in this forum were someone suggest banging it on a table a couple times, not to hard that you'd dent it but a good enough bang. Worked like a charm! I tried the trigger and slide method but while the error message went away the zoom wouldn't focus. Try banging it, it sounds bad but it worked wonders!

Mar 06, 2008 | Fuji FinePix Z1 Digital Camera

1 Answer

Error message now showing


Does the lens extend and retract as normal?
If so then the internal drive gear for the zoom / focus has been damaged and will need to be repaired/ replaced.
If the whole lens will not move or is stuck then it needs to be removed, stripped and re-assembled.

Feb 18, 2008 | Fuji FinePix F45FD Digital Camera

1 Answer

Sony DSC-w50 zoom not working


switch on when the lense extends take the end of it and gently twist and pull the lense you may hear it click be gentle do not force it then switch off and on again and this will solve the problem 98% of the time.

Jan 25, 2008 | Sony Cyber-shot DSC-W50 Digital Camera

2 Answers

ZOOM ERROR


What just started? The camera? Do you have fully charged batteries? Did you check the manual?

Dec 30, 2007 | Fuji FinePix S7000 Digital Camera

1 Answer

Focus error


When that problem has happen to my Fuji A210 is because the slider that cover the lense has not gone all the way to the right ! I usually move the slider strongly 2 o 3 times to the left and to the right, and then turn the camera on. Fortunately, that trick has worked for me, so I hope it also works for you !!!

Nov 09, 2007 | Fuji FinePix A210 Zoom Digital Camera

2 Answers

Turn the power off and on again....this is what appeared after i download some pictures to my computer for the first time. When I do this the same words appear on the screen and I am unable to take any...


If this error message appears, turn off the camera and remove the batteries for 30 seconds. Afterwards, reinsert the batteries and turn the camera back on. Perform a manual reset of the camera.

Aug 24, 2007 | Sony Cyber-Shot DSC-S40 Digital Camera

1 Answer

Help


If this error message appears, turn off the camera and remove the batteries for 30 seconds. Afterwards, reinsert the batteries and turn the camera back on. If this doesn't work, perform a manual reset of the camera. If you need an online manual here is a link with troubleshooting http://www.docs.sony.com/release/DSCW40_EN.pdf

Aug 17, 2007 | Sony Cyber-shot DSC-W50 Digital Camera

Not finding what you are looking for?
Fuji FinePix S700 Digital Camera Logo

Related Topics:

36 people viewed this question

Ask a Question

Usually answered in minutes!

Top Fuji Cameras Experts

kakima

Level 3 Expert

102366 Answers

Greg Cann
Greg Cann

Level 3 Expert

1114 Answers

Steven Wander
Steven Wander

Level 3 Expert

579 Answers

Are you a Fuji Camera Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...