Question about Sony KP-57HW40 57" Rear Projection Television

1 Answer

Sony KP-51WS520 Stan by light bliks 9 times. The TV will not power up i have unpluged and waited 10 MIn still Blinks 9 times help

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 4,402 Answers

G-board 12 0r 13 volt regulator .... this is a PLUG IN board... no sodering involved and very simple to replace.. i ordered a brand new complete g-board (for around $60 back then) unpluged the old one pluged in the new one in less than 5 minutes and the tv has been working without any problems of not turning on ever since.
check with ptscorp.com see if they have the board on hand.
also check D6116 or D6301 is open (G board).

Posted on Dec 21, 2007

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

50 or 52 inch RCA HDTV about 10 yrs old the power light blinks 9 times then 5 times then 9 times and won't go off unless unplugged, won't turn back on


i have seen this before and sorryy to say if unplugging for 5 or more min and that dose not fix it may need to be replaced not many people fix them these days but not impossable

Aug 25, 2015 | RCA HD52W56 52" Rear Projection HDTV

1 Answer

I was watching TV it shut off and the power button flashed a bunch. I unplugged it waited for a while plugged it back in. It did not turn back on until i held down the menu button on the set.


I found the following blog on the web.


Panasonic Viera Plasma Failure Page



November 14, 2010 ·







Blink Codes and what they mean (8-13):



8 blinks Driver SOS 3 SS Board (SS energy recovery circuit)

9 blinks Panel Config. SOS

10 blinks Sub 5v SOS / Main 3v SOS DG BoardDTV 9v SOS / Tuner Power SOS

11 blinks Fan SOS PB Board

12 blinks Sound SOS H Board

13 blinks Communication error DG Boardwith IC8001








Make sure the inside of the TV is clear of DUST especially by the power supply and fins.

May 02, 2015 | Panasonic Viera Tc-p42x5 42" Inch Flat...

3 Answers

Status light is blinking red, power button orange nec vt700


Hello
Look at the number of blinks of the status light.
[1] If it blinks at one cycle (0.5seconds On and 2.5seconds OFF) : Lamp cover error or lamp housing error. Replace the lamp cover or lamp housing correctly.
[2] If it blinks 2 cycles (0.5 seconds ON and 0.5 seconds OFF): Temperature error. The projector is overheated. Move the projector to a cooler position.
[3] if it blinks at 4 cycles (0.5 seconds ON and 0.5 seconds OFF): Fan error. Fans sill not work correctly.
[4] If it bliks at 6 cycles (0.5 seconds ON and 0.5 seconds OFF): Lamp fails to light. Wait a full minute and then turn on again.
[5] If it blinks continous (Red): Lamp has reached the end of its life. Lamp replacement messege will be displayed. Replace Lamp with same type and number. After replacement reset lamp hour. OK.

Sep 10, 2011 | NEC VT700 Projector

1 Answer

Plasma tv stop and power light just blinks. Try unplugging and waited to cool down. Still just blinks. Model th-42pz77u


Hi,
Symptoms and red light blinking 10 times shows that DG board is defective in this tv and it is available HERE for $119
These info will help you to decide about get tv repaired or buy new tv.
Thanks.

May 15, 2011 | Panasonic Televison & Video

1 Answer

WONT CUT ON POWER LIGHT JUST BLINKS


Unplug the power cord, wait and watch the power light until it goes out completely, then wait 3 - 4 more min. and then plug the power cord back in and it should turn on.... its a hassle but at least it works.

Jun 26, 2009 | Panasonic Viera TH-42PX80U Plasma TV

2 Answers

Six (6) blinks on the Timer/Standby led


6 blinks means lamp thermal fuse blowing, replace thermal fuse.

See here

Aug 30, 2008 | Sony KP-57WS500 57" Rear Projection...

4 Answers

Sony tv kv-36fs120 will not turn on


Use a hair dryer on the back right side of unit. Humidity sensor may be causing the unit to stay off. The hair dryer may also remove dust causing a false humidity detection

Nov 10, 2007 | Sony FD Trinitron WEGA KV-36FS120 36" TV

Not finding what you are looking for?
Sony KP-57HW40 57" Rear Projection Television Logo

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sony Televison & Video Experts

The Knight
The Knight

Level 3 Expert

75846 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Jerry Greenberg
Jerry Greenberg

Level 3 Expert

1689 Answers

Are you a Sony Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...