I have a 36in Rca the tv had problems with cable conection so we would jiggle the cord and it would play dont no if that is related beceuse it went on for a while then suddenly the tv shut off and will not turn back on i have removed the the cover to make sure the grey abd black plugs were still in the board and that the fuse right there had not been blown. With the cover off i try to restart the tv, it attempted to run but cut off an on then off completly there is a clicking sound coming from the left side of the board if you are facing the tv unit please advise
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Some RCA TV's have a "video" option that requires you to use the original remote control to cycle up or down the channels.
Also, try unplugging the TV's from the power receptacle for 30 minutes....some times, that will cause the TV to reset.
With the power cord unplugged, manually push the power button on the front of the TV to discharge all capacitors.
Ensure the 30 minute is complete before plugging it back in.
Let me know if this works.
You must have a AV card connected via the USB which can be used to link the laptop to the TV. The video and audio from the AV card can be connected using the RCA cords to the video input( yellow) and audio inputs( red and white).
Many of RCA's smaller sets didn't come with AV input jacks. They only had a connector for an antenna or cable wire. To use a device like a DVD player or game console with a TV like this, you need an RF modulator. This takes the audio and video signals (those three cables you can't plug in to the TV right now) and creates a signal that the TV can tune in on channel 3 or 4. Unless you replace the TV with one that has AV inputs, the modulator is your only solution.
Thats ok my family is that same. you have to plug the video cords ( yellow white red ) into the output of the dvd vcr combo ( i think it says vcr output) then connect the ( yellow white and red ) video cord into the input your televition. the input may be at the back or front or both.
It looks better and cleaner if you plug it into the back ones. It should say input and be ( yellow white red ) colours. once you have connected them both up to eachother you turn the power on (if you left it on dont worry its fine) and tuen the vcr on and tv on at the power buttons.
Then turn the tv on to av1 or video what ever your tv calls it. put a vhs or dvd in and press play and it should work.
Thanks for asking if you have any other problems i am happy to help please dont hesitate to ask
It could seem to be a power cord problem But when you move around the cord you are realisticly flexing the printed circuit board assy. If you know all the safety issues around the servicing a solid state tv, then Of course I will assit you, in any way I can, But you must be aware of the high voltage that these sets store , even if they Are unplugged. Its a total safety issue. If you have no experience using a multi- meter as well as the safety issue awarness, then PLEASE seek a pro to assist you with this reapir, as it will get worse in the long run and cost ya more to fix, as everytime you move around the cord and the set shuts off, then goes on , your surging the componets!. Good Luck