hi, I own a Kitchen aid classic , stand mixer, and the problem I have is, the pin that holds...
(More)
hi, I own a Kitchen aid classic , stand mixer, and the problem I have is, the pin that holds together the motor head to the stand always comes out. Also sometimes when I tilt the motor head I can hear a clicking sound. My Mixer is not even 2 years old. How big of a problem is that and how can it be fixed?
I own a kitchen aid Classic mixer and have used the shredder attachment on a number of occassions....
(More)
I own a kitchen aid Classic mixer and have used the shredder attachment on a number of occassions. Tried to insert the attachment recently and can't get it all the way in. Goes in except for about the last inch, so it will not seat to 'lock' in place. I remember reading this a a common problem, but can't find anything on it. Nothing has changed, no damage, why all the sudden it won't fully insert? Thanks. Chris
I put in a new worm gear that had broken due to a part falling in the mixer bowl. When I...
(More)
I put in a new worm gear that had broken due to a part falling in the mixer bowl. When I re-assembled the mixer it would not start. I put on a new wire plug and still no current to the mixer? The mixer motor was running fine before I took it apart. I had started a few times before taking it apart and the motor ran but the mixer would not turn because the gear was broken. I know the motor was fine and current was getting to it. Is there a reset switch if you take one of these mixers apart?
Our mixer is about 5 years old. I noticed that the beaters are hitting the bottom of the bowl and...
(More)
Our mixer is about 5 years old. I noticed that the beaters are hitting the bottom of the bowl and the head of the mixer seems to be tilted down when you look at it from the side. I mean that the beater, front part of the motor is lower than the back of the motor. There are many screws, some of which were loose and I tightened them, but that didn't help. Also, there is a pin that holds the motor to the base and that is loose and slips almost out of the base when i am mixing cookie dough etc. The whole motor jiggles and then I realize that the pin is almost out of the hole. help!