Question about Compaq (DEFYM-AA) Networking Switch

1 Answer

Diagram for defy 735mf stove

Diagram for the stove top part of the stove

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 51 Answers
Re: diagram for defy 735mf stove

Please search in

Thank you..

Posted on Jan 04, 2008

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Install both computers withdual monitors

Ok, so the idea of this KVM is to allow two computers which are dual monitor enabled to share one set of dual monitors. This means that PC1 can output to two monitors at once and PC2 can output to two monitors at once, however you only have two monitors.
You should take two cables and plug in both to the dual display output on PC1 (if supported) and then plug them into 'A/B' Computer 1, you should then take two cables and plug them into the dual display output on PC2 (if supported) and plug them into 'A/B' Computer 2.
Now take two cables and plug one into Monitor A and connect this to one of your screens and plug one into Monitor B and plug this into your other screen.

You should see this in the diagram here:

Only one PC can be used at a time.
To support this the back of EACH PC should have a graphics card with two VGA output connections like this:

Nov 11, 2013 | Linkskey (lkv-dm02sk)

1 Answer

Mgf 1.8 vvc,2001,y reg

You need wiring harness diagram to be sure where to connect it.

May 16, 2008 | Networking Hubs & Switches

1 Answer

Sometimes the 8 ports 1-8 stop functioning and sometimes the other 8. Presently half the switch is dead and only ports 9-16 are functional. The switch is atleast 5 yrs old can it be repaired. Rgds and...

Yes it can be repaired. You will need to hunt around for a circuit diagram for it. I have four of these old things in commission at home here and this exact thing happened to one of them. I ran a multimeter over the power supply circuit board (top left) and found one of the capacitors out of spec. The resulting limited power to the rest of the unit meant that it couldn't cope with traffic on all ports. Replaced and fixed the problem. Needed soldering iron and multimeter. Good luck, hope this helps.

Mark Vincent

Jul 06, 2011 | D-Link DES 1016D (DES-1016D) 16x10/100...

1 Answer

How to repair the dso power supply ? is there a circuit diagram ? thx

repairing a power supply do not need a diagram often faulty on a power supply are the regulator transistor,capacitors,resistors,and diodes. just check these parts and you can fix the power supply.check also for loose contacts and connectors this also cause a fault on the power supply.

Jan 18, 2011 | NetGear ProSafe JFS524 24-Port Ethernet...

1 Answer

I would like to know the schematic diagram for light stairs that can be controlled on every floor, like for example if I have 6 floor.

This wires like a 4 way switch, then you can install multiple extra switches of double wire, double throw (4 way) on multiple floors.

Sep 16, 2010 | Interex MultiSwitch 900

1 Answer

Do we need a driver to set up the connections of pc's to a GH 4080SE hub?

No. You do not need a driver

This diagram illustrates use of an Ethernet hub or switch on a home network. See below for a detailed description of this layout.

Aug 27, 2010 | Genius GH 4080 SE 8-Port Ethernet Hub...

1 Answer

Switch hook up

do you have the users manual???
it has all the connection diagram and instruction.
if you don't have, please email me at

please rate, if this answer your question

thank you

Oct 16, 2008 | Linksys 5-Port Ethernet Switch (SD205-UK)

2 Answers

Supply problem

If you could state your problem cleary, you might get a better answer.
What can't your switch do?
Does it power on? Switched come with a power adapter that plugs directly into the wall power, then other end into the back of the switch. If it doesn't come on, suspect internal problems

Nov 11, 2007 | 3Com (3C16593BN) 24-Port Ethernet Hub

Not finding what you are looking for?
Networking Hubs & Switches Logo

Related Topics:

623 people viewed this question

Ask a Question

Usually answered in minutes!

Top Compaq Networking Hubs & Switches Experts


Level 3 Expert

4327 Answers


Level 3 Expert

18258 Answers

Brian Sullivan
Brian Sullivan

Level 3 Expert

27725 Answers

Are you a Compaq Networking Hub and Switch Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides