Question about Mitsubishi VS-60603 60" Rear Projection Television

1 Answer

Tv locked during power shortage - Mitsubishi VS-60603 60" Rear Projection Television

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Mitsubishi Master
  • 1,779 Answers

Leave it unplugged over night and then try it. If not, then I would say your regulator ic took a hit.

Posted on Oct 03, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I need a Power Board for my 46" LTD Plazma TV ...it clicks and wont turn on . Where can I but one?


Sure it is just the power board? did you check if there were no shortages in the circuits? because if a shortage caused the power supply to die, the next power supply will die too. Don't start changing parts, before you know for sure what is defect and why.
Just saying.

Jan 19, 2015 | Televison & Video

1 Answer

Bosch tca5201 expressomachine freezed up while in service program


You might want to post this question in a different section. This is the computer section.

Jul 14, 2012 | Computers & Internet

1 Answer

My sony trintron tv is not turning on i got just the stand by botton blinking


There could be a shortage in your power supply so you change the power supply or it be the power cord for your tv

Jun 13, 2011 | Televison & Video

1 Answer

Power Window problem sebring sedan 2001


it could be possible that the window switches on each side as gone bad or possibly you have a shortage dnt know how exactly to pin point the shortage without an amp or voltage tool..but if the master window switch is working fine then yes you do have a shortage or bad switches but while you are at it check all window fuses

Nov 21, 2009 | 2001 Chrysler Sebring

1 Answer

Router not working after pc power shortage.


It is very common during any type of electrical spike (like power surge or lightning strike) to have the increase in power go through the network card over to the router and burn it up. This is not an issue if you are connected wirelessly, only when you are hard wired to the router. Also possible the surge came through the power source and got both of them. I would hold down the reset button for about thirty seconds to see if your light stops blinking. If it stops you can probably go in and configure it to connected again. Hope this helps

May 26, 2009 | Belkin (F5D7230-4) Router (587009)

2 Answers

Ws48511 no poweron


had the same problem with the blinking light on the front of the TV and it would not power up. I read all the problems everyone was having and thought I was going to face a huge repair bill. The service guy came out, pulled off the front panel where the speakers are and disconnected the circuit for the front display panel. 3 1/2 minutes in my house, $90 service call. Apparently, when you give the TV too many commands at once, it's safety feature is to"shut down and lock up". He mentioned also that sometimes when these sets get to be about 4-5 years old, the wires in front can "leak" causing a shortage and then locking up the TV. I keep the circuit unplugged and operate the TV solely by the remote. Give it a try, what can it hurt!! Hope this helps.

Oct 29, 2008 | Mitsubishi WS-55511 55" Rear Projection...

2 Answers

Restart problem


You may have to hard reset it by unplugging the cord itself and plugging it back in. When power comes back during power shortage, there may be a power surge rushing to the modem/router causing it to behave abnormally. Also, you may want to put power surge protection on it as it may damage you modem/router as i did mine.

Sep 17, 2008 | Acer Aspire 5100 Notebook

1 Answer

Hi, my sharp 28LF-92H flat screen tv just turned itself off last night. ive checked the plug & fuse & all appears ok but the tv just will not switch on, there's no sign of any power being delivered...


YES THERE A SHORTAGE OF POWER SOMEWHERE, ALSO THE POWER BOARD IN THE TV CAN OUT ALSO .TRY TO UNPLUGG IT FROM THE TV THEN REPLUGG IT AND SEE WHAT U CAN

Sep 06, 2008 | Televison & Video

1 Answer

Tv wont come on had a powersurge hasnt come on since why?


TV fuse open /replace
If same proiblem fuse pop the power IC was shortage.

Jan 03, 2008 | Panasonic CT-32G19 TV

Not finding what you are looking for?
Televison & Video Logo

Related Topics:

113 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Televison & Video Experts

matt martin
matt martin

Level 3 Expert

1213 Answers

The Knight
The Knight

Level 3 Expert

74482 Answers

Jaime Hernandez

Level 3 Expert

2318 Answers

Are you a Mitsubishi Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...