Question about Kenmore Washing Machines
Enter model full model number in the website below to get parts and schematics.
Parts & Accessories |
sears parts - Online parts
Sears Parts and Sears Repair
If you do not find the part , give me the full model number , as on service tag, and tell me what part you need. I will find the part for you.
Posted on Oct 02, 2009
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
You first have to remove the 2 phillip head screws on your face panel.There is one on each side located about 1 inch from the front corner.tThese 2 screws are holding down the entire front timer panel.Ok,now lift up & forward at the same time so you can swing back this timer panel and get it to balance back out of the way.Now, it becomes a little harder,locate the harness that your lid/spin switch is on by unscrewing the 2 screws on the spin switch.Pulling the bad switch away from your cabinet will expose the harness ,that way you will see where it is plugged in.After unplugging it your now ready to plug the new one in and just tuck in the harness in the cabinet.Flip the timer panel back down and screw it back down.Your done !!!
Posted on May 20, 2008
Hi, Remove the cap on the agitator and then remove the inside cover. There is a 7/16" bolt under the inside cover. Remove the bolt and the agitator will lift out. Seperate the 2 pieces of the agitator and replace the dogs. You might have to use a flat blade screw drive and punch out the 4 tabs around the bolt hole in the agitator if this applies.
I hope this helps you. Please let me know if I can assist you further.
Posted on Jul 03, 2009
F35 is a water level error.
The water level switch (pressure switch) has malfunctioned.
If you remove the top panel, three screws in the back, you will have access to the pressure switch.
With the tub empty, remove the vinyl hose from the switch and blow backwards through the hose to clear any restrictions.
If the fault codes return after doing this, you will likely need to replace the pressure switch.
Also - please be sure to use He soap.
Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question.@#$%
Posted on Sep 26, 2010
Tips for a great answer:
Feb 08, 2016 | Kenmore Washing Machines
Jul 30, 2015 | Kenmore Washing Machines
Feb 12, 2012 | Kenmore Washing Machines
Jun 22, 2011 | Kenmore 24032\24036 Top Load Washer
Jan 04, 2011 | Kenmore Washing Machines
Sep 17, 2010 | Washing Machines
Feb 05, 2010 | Kenmore 15944 Top Load Washer
Sep 18, 2008 | Kenmore 22422 Top Load Washer
46 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: