Question about Polk Audio Atrium 55 Main / Stereo Speaker

Open Question

Polk audio atrium speaker blown again, polk fixed once but won't do again. Any ideas on how to repair? thanks

Posted by on

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

tmf23
  • 6 Answers

SOURCE: polk rti6 tweers blown...4 speakers.....can

It may be possible to have the tweeters repaired by Polk however if you have the skills your least expensive route would be to replace the tweeters and install them your self. I would recommend using the internet to find replacement tweeters either through Polk or possibly Ebay, or Amazon. Each tweeter has 2 wires that must be removed before uninstalling. Note the polarity and where they connect. red is + POSITIVE , BLACK IS - NEGATIVE

Posted on Apr 15, 2011

  • 14 Answers

SOURCE: need to replace woofer in

eBay is always a good place to start you can get anything, the problem is replacing the driver in just one will give uneven sound as it would probably be dificult to find one that matches, i would advise replacing both, it will need to handle 160watts max and go down to atleast 75hz the crossover will take care of the high frequency range so this is not as important but it should be bale to handle atleast 8khz (8000hz) and pay close attention the the resistance of the speaker, it will probably be 4 ohms but could be 2 or 8 depending on how its wired, you can check by connecting a multimeter set to 100 or 200 ohms and connecting it to the 2 terminals on the speaker (after its taken out of the cabinet) the meter will read 0.0x where x is the resistance nearest to 2 4 or 8.

Posted on Aug 28, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where do I find a replacement speaker for my Polk Audio CS101


Manufacturer or authorized factory repair center for Polk.

Sep 16, 2016 | Polk Audio Audio Players & Recorders

1 Answer

Need to replace woofer in polk atrium 45. where can i find a decent speaker to fit?


eBay is always a good place to start you can get anything, the problem is replacing the driver in just one will give uneven sound as it would probably be dificult to find one that matches, i would advise replacing both, it will need to handle 160watts max and go down to atleast 75hz the crossover will take care of the high frequency range so this is not as important but it should be bale to handle atleast 8khz (8000hz) and pay close attention the the resistance of the speaker, it will probably be 4 ohms but could be 2 or 8 depending on how its wired, you can check by connecting a multimeter set to 100 or 200 ohms and connecting it to the 2 terminals on the speaker (after its taken out of the cabinet) the meter will read 0.0x where x is the resistance nearest to 2 4 or 8.

Aug 26, 2011 | Polk Audio Atrium 45 Main / Stereo Speaker

1 Answer

Polk rti6 tweers blown...4 speakers.....can these tweeters be repaired


It may be possible to have the tweeters repaired by Polk however if you have the skills your least expensive route would be to replace the tweeters and install them your self. I would recommend using the internet to find replacement tweeters either through Polk or possibly Ebay, or Amazon. Each tweeter has 2 wires that must be removed before uninstalling. Note the polarity and where they connect. red is + POSITIVE , BLACK IS - NEGATIVE

Apr 15, 2011 | Polk Audio RTi6 Main / Stereo Speaker

2 Answers

Dose'not work the light dose'nt come on


if you can try and open it up and see if there is a fuse inside of it it might of popped

Sep 30, 2009 | Polk Audio PSW202 Subwoofer

1 Answer

Mt polk audio satelitte speakers are blown, what do i need to do to fix them myself?


depending on what you mean by 'blown' .
a kit is available to replace the surrounds that anyone with a mild sense of mechanical abilities can do.

If the cone is frozen , you may need to buy a new set of speakers.

Nov 28, 2008 | Audio Players & Recorders

1 Answer

I have a set of RM300 Polk sub-sattelite speakers. Have had them for some time and still love em but.... The foam surrrounds on the bigger sattelites have disintegrated. Polk says too old cant fix. ...


Yes they can be re-surrounded. It is not that hard, it just taes some practice. How big are the speakers? Look for a local speaker repair shop. They are few, but still exist. The hardest part is finding the correct surround. As long as the remainder of the speaker is in good shape, you will find these to be good as new once done. FIrgure about 2-3 days to complete the job properly.
Dan

Apr 09, 2008 | Audio Players & Recorders

Not finding what you are looking for?
Polk Audio Atrium 55 Main / Stereo Speaker Logo

Related Topics:

124 people viewed this question

Ask a Question

Usually answered in minutes!

Top Polk Audio Audio Players & Recorders Experts

 Grubhead
Grubhead

Level 3 Expert

5056 Answers

The Knight
The Knight

Level 3 Expert

74136 Answers

ed_dantes

Level 1 Expert

7 Answers

Are you a Polk Audio Audio Player and Recorder Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...