I dont seem to have any power going to my key board

Does your 12 volt remain at 12 after it shuts off or does it drop to 0?..This model was known for issues with the LED lamps themselves but Ive seen a number of sets where the LED's were fine and it was the power supply or main boards bad

Power supplies are number one for going bad on TVs. I think it is worth replacing the part. Sounds like it is over heating and coming back on line when it cools.

The board will most probably need replacing. Almost certain.
I repair this brand for the manufacturer.

If you wish to get some details; visit the site linked here. Pull up older posts. http://electronicshelponline.blogspot.com/

Adjust the REED swicht , see diagram, clean it, and tight the plug very well.

2) clean the ribbon cables, for keypads, clean it.
3) tight the connector from display board vs lower board too
see the block diagram
After you fix it. RUN the software calibration for diagnostic, troubleshooting. too
God bless you

hello again,

no thier doesn't seem to big issue with with reconditioned control panels in fact i dare say yours is good since the dryer didnt start with the original one and still wont start with the one you have replaced. having checked teh thermal fuse to be good and with basically 2 control boards yet the dryer doesnt run it seems very possible the motor is going to be the problem...not sure what led ya to the control board yet it the drum doesnt turn the very part that turns it when power is applied to,if it has powewr to it and doesnt turn the drum it would seem to me its bad....dont get me wrong on this but its like having a broken leg and going to the doctor and saying i believe that my heart is weak since my legs hurts and totally disregarding the broken leg


GENE

Hello,

Remove the battery and attempt to have the unit only on A/C Power and see if that makes a difference.

Try going into the BIOS on boot and look to see if it is set wrong. To access BIOS, you USUALLY, but not always, tap the Del or F2 key once or twice a second while booting up. This depends on your BIOS and PC model. also, seem to me that if you move your mouse or hit a key the monitor should come out of power save. Try right clicking on the desktop and going to properties. Changing a setting(power options, screen saver, etc.) in there may fix the problem.

dont worry.its only the key pard problem.you need to replace the key pad and dont forget to ask the repirer to clean the circut board.avoid hard use of key pad.take care

check your power supply unit