My keyboard will not work. I changed the

make sure the replacement batteries are fully charged. If they are, you will probably have to reconnect the keyboard to the receiver by pressing the small "connect" button at the bottom of the keyboard.

You also need to click on the receiver button. After the receiver button is clicked then you would need to click the mouse button located under the mouse. If all of this was done try replacing the batteries again with a new set of batteries. I've seen new batteries not work before that has died while sitting in it's package.

disconnect it and try them with the laptop and see if it will work,then later reconnect it again and see.

reconnect the keyboard with censor

The keyboard is not recognized by your PC. By the way, do you have the software installer for your keyboard.? Run the installer in your PC, and try again
if it now recognize the keyboard.

try to shutdown your pc and reconnect the mouse. after that boot your computer...

Thanks! I fixed the problem by installing a USB mouse and using fn+f9. That unlocked the mouse so I could use the pointer leaving just the keyboard problem. I then tried reconnecting the wireless keyboard (by using the button on the receiver and under the keyboard) Hey Presto!!

Unplug the USB (or PS/2) plug for a couple of seconds and reconnect them. That worked for me when this happened on my older Logitech keyboard.

Did you replace the batteries in the wireless keyboard? If not try doing that first and then use the following info.

Normal 0 Press the Receiver button (and the lights will start flashing.
Then if the Keyboard isn't working, press the small RESET/CONNECT button on the back of the board to connect the keyboard to the receiver.

If the MOUSE isn’t working, push the small RESET/CONNECT button on the back of the mouse to connect to the receiver. Then they should work okay.
Hope this helps. Bud

Hi. I have just worked out how to solve this as I had a similar problem. When you change the batteries of a Belkin Wireless Keyboard model F8E332ukBNDL you need to reconnect the keyboard to the wireless receiver that plugs into the USB port. To do this you press the 'Connect' button on the receiver and also press the green LED connect light at the top right of the keyboard - the one that flashes each time you press a key. I'm not sure in what combination you press these but I pressed them both and it worked.