Question about Alpine CDA-9831 CD Player

1 Answer

How do i fix my bass and treble on my deck - Alpine CDA-9831 CD Player

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 31 Answers

If you are having distorted or muffled sound from your deck then this could be caused by either 1)poor settings 2) bad output amplifier or 3) blown speakers, inspect 1 and 3, if ok then is 2. hope this helps.

Posted on Sep 30, 2009

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

bbtoast
  • 319 Answers

SOURCE: Cannot Set the Treble & Bass

Bass and Treble controls allow you to adjust each setting from
-7 to +7 once you have calibrated your vehicle's interior sound with the optional Alpine IMPRINT software.

Is this what might be causing your setup not to work?

Posted on Jan 05, 2008

jyackle5
  • 8197 Answers

SOURCE: finding treble and bass adjustments on my stereo

Here is a manual for the radio. If you go to page 14 it will tell you how to set the EQ.

http://vault.alpine-usa.com/products/documents/OM%20CDA-9835.PDF

Good Luck Please Rate FixYa!

Posted on Dec 19, 2008

  • 2 Answers

SOURCE: how to adjust treble and bass

At the lower left of the unit, just right of the power button is a button marked LD, with A-M below that. Push this button and the display will say BATT, then, in a couple seconds it will display 2 numbers. The left number is the bass and can be adjusted with the select arrows (left & right arrows). The right number is the treble and can be adjusted with the volume arrows (up & down arrows). If you push the LD button once more, it will display BAL, then 2 numbers. The left is the left-right balance & the right is the front-back balance. They can be adjusted in the same way with the arrow keys. Hope this helps someone.

Posted on Mar 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to adjust bass and treble and surround sound


On the Remote Control
Press
1 TONE
ToneControl•OFF-
2 Use selection button to select "ON".
ON : Allow tone adjustment (bass, treble).
OFF : Playback without tone adjustment.
NOTE
The tone cannot be adjusted in the direct
mode.
3 Press
to select an item to be set, and use
TONE
to select a setting value.
Bass : Adjust low frequency range (bass).
• -6dB - +6dB (0dB)
Treble : Adjust high frequency range (treble).
• -6dB - +6dB (0dB)
"Bass" or "Treble" can be set when "Tone Control" is set to
"ON

Oct 24, 2014 | Denon Avr 391 5.1 Channel 110 Watt...

1 Answer

Pioneer DEH-P550MP


www.pioneerelectronics.com/PUSA/Support

May 23, 2014 | Pioneer Car Audio & Video

1 Answer

How do i find out what sound card my p.c is using? i'm on windows vista, and need to change the bass and treble level ?


Most laptop sound card do not have a setting for bass and treble.
You can use external powered speakers that have bass and treble settings and connect these speakers to the headphone socket on your laptop.

Jun 26, 2012 | Computers & Internet

1 Answer

What are the frequencies that the bass and treble controls on a Yamaha AX-396 amplifier control? I recorded alot of music direct from the amp to my pc with the bass and treble controls at max and need to...


The bass and treble controls (as well as volume) have no effect on the recorded output if you're using the traditional jacks a tape deck would use. Only PRE-OUTS get massaged by sound controls.

Even if you DID affect the recorded signals, WHY are you using such exaggerated settings? Or was it by mistake?

In theory, passing the modified output back through the same controls (set to Minimum this time) would undo most of the unwanted effect. Assuming their precise and mirror image for gain and loss.

Aug 23, 2011 | Yamaha AX-396 Amplifier

1 Answer

What are good settings to have to make the music sound clear for a jvc KD-R310 deck?


you will need to access the bass and treble setting on the unit.
If you have stnadard speaker then dont put the bass to high as you can not turn the volume up high.
The same for the treble.
Set them at about the same and turn the volume up until it sounds good.
If it is to quiet then turn the treble and bass down and then the volume up more

Mar 02, 2011 | JVC AM FM CD DET FACE CAR STEREO

1 Answer

I Have A Sony Xplod GTX GT710 Cd player in my truck. And I have been trying to figure out how to balance the bass to my subs and leave the treble to the rest of the speakers. How can I Do this?


the trick is not to use you deck to control the bass. use the amplifier and set all you radio setting to 0 this will allow you to fine tune a little audio when you need to, make all your bass tuning setting at the amp. not the deck,

Sep 02, 2009 | Car Audio & Video

1 Answer

Cant control bass or treble


when you bought this did you just get the in-dash unit or did it come with a brain unit as well .........if it was just the in-dash player you need to buy a brain unit to control bass & treble and other features for this unit when pioneer sold this the dash unit sold for$495.00 but the brain unit cost $599.00 it was a price grabber cause they wouldn't tell you it needs a brain unit (the actual full unit sold for $1200.00 brain/dash) yet it works with other pioneer in-dash units the person you bought from probably upgraded to the avhp-7500DVD and kept the brain unit from the one he sold you but good news its a few years old so i would checkout eBay for the brain unit
hope this answered your problem good luck

Dec 24, 2008 | Pioneer AVH-P6500DVD Car DVD Player

1 Answer

New car, no manual


There is no straigt forward bass and treble adjustment. You must adjust in either the (x-over) or (users EQ) function. It is a bit tedious but performs the bass and treble adjustments at multiple frequencies.

Aug 24, 2008 | Alpine CDA-9833 CD Player

1 Answer

Spares


Bass Treble,bal controls can be clened with contact cleaner.
Drive belts audio heads may be available at the sansui web site or mcm electronics.com.
GOOD LUCK
BIGRED

Apr 01, 2008 | Audio Players & Recorders

1 Answer

Troubleshooting on Adjusting Treble/Bass


Look in your owners manual and make sure you are turning the right knobs or pushing the right buttons once you have the adjustment screen for the bass/treble showing. It could be that they use different knobs/buttons than the volume control. If you are using the right controls, then you have a problem that only a shop can fix. You might reset by taking away all the power (acc and bu) for a couple minutes and then reconnect, but if that doesn't help then it time to go to the shop.

Aug 10, 2007 | Alpine CDM-7861 CD Player

Not finding what you are looking for?
Alpine CDA-9831 CD Player Logo

121 people viewed this question

Ask a Question

Usually answered in minutes!

Top Alpine Car Audio & Video Experts

xxxxxx xxx

Level 3 Expert

4834 Answers

Tygh Duval
Tygh Duval

Level 2 Expert

300 Answers

Jaime Hernandez

Level 3 Expert

2315 Answers

Are you an Alpine Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...