COULD BE FANS NOT WORKING. TAKE BACK OFF AND SEE IF TURNING, CLEAN THEM, OR TURN STAND BY MODE OFF OR GO TO SONY.COM, TROUBLESHOOTING OR
The STANDBY light is flashing on the television and there is no picture or sound.
The STANDBY light will flash if an issue is detected within the television. This can sometimes be resolved by simply following the steps below to reset the television.
Turn off the television.
IMPORTANT: For a projection television that uses an internal lamp, wait 5 minutes after turning off the television to allow the lamp to cool before continuing with the following steps.
Unplug the television power cord from the electrical outlet.
Let the television remain without power for 60 seconds.
Plug the power cord back into the electrical outlet.
NOTE: If the television is plugged into a power strip or surge protector, remove it from the power strip or surge protector and plug it directly into the wall outlet. If the issue is resolved, the problem is with the power strip or surge protector and not the television.
Turn on the television.
If the issue is still unresolved after following all of the troubleshooting steps, service may be required. Please note the number of times the STANDBY light flashes and relay that information to the service center.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
D 6116 and D 6301 on the "G" board, do not re-solder as this
will fix the problem temporary. Or Panel Module Error or Thermal Error. If
it is intermittent 9 blinks, meaning sometimes the TV comes on and other
times you get flashing, then change the switching regulator on the
"G" board or check connections. Make sure the regulator is -12
or -13 (negative). ( blinks of standby light to Sony CRT based TVs denotes this. Check this link, if you wish to know more.
you are not familiar with electronics, do not attempt to repair! Whether you sufferfatal electrical shock!
Instead, contact the nearest service center!
The standby light shouldbe blinking is a pattern of a count followed by a pause then the count again repeatedly. If you can post that count here, we can use that to indicate the circiut in which the problem exists. That will determine the probable cost to repair.
I have a Sony SRS BBE Trinitron (WEGA). The last few days when I tried to turn it on using the remote the Red Light would go on but the TV did not turn on. I would have to press the power button again to turn it on.. I tought the remote battery was just low.
Today when I tried to turn it on nothing is happening and the Red Light is blinking 9 times ??? I tried to unplug it and try it again, still does the same thing ???
My picture would go out after several minutes but I still had sound. I
took the rear cover off and blew all the dust off with compresed air.I
did this for a few times over several days nothing happened.I also took
off the rear circuit board that attaches to the tube with a round pin
socket and blew that with compressed air and put it back on. The TV has
now worked for two days without the picture going out. It
worked!!!!!!!!!!!!!! My TV is 9 years old.