Question about Pioneer SX-315

2 Answers

Dead no power.. checked main fuse, worked fine last night, went to turn it on today and nothing. its a sx-316 not sx-315, I say this because it tells me this is not a valid model#, but sx316 is printed on the front and on the back sticker

Posted by on

  • Matthew Albert
    Matthew Albert Sep 30, 2009

    I get 120AC to the main relay but no voltage on the low side,main relay is not clicking in.

    No power going into the primary side of the main transformer.

    This radio is about 4-5 years old looks new from inside and out, I used it everyday with the TV, but never ran maxed out,,,, mostly at about 30-50% volume.

  • Matthew Albert
    Matthew Albert Sep 30, 2009

    I get 120AC to the main relay but no voltage on the low side,main relay is not clicking in.

    No power going into the primary side of the main transformer.

    This radio is about 4-5 years old looks new from inside and out, I used it everyday with the TV, but never ran maxed out,,,, mostly at about 30-50% volume.

×

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

The Pioneer sx-316-5 has a protect mode.if it will not power on from the power stand by button and you tried un plugging the unit for 60 seconds then try this-with the unit plugged in and in stand by mode push the enter and advanced surround buttons at the same time for 2 seconds-you may get power back if your unit was in the protect mode.check all of your connections first to make certin that there is not a disconnected wire or connecter.

Posted on Feb 11, 2015

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 336 Answers

Check the resistance of the primary on the main power transformer, (with power off) should be 1-3 ohms. If open you need a new transformer.

If good turn it on and check for ac voltage (120v) there.

Posted on Nov 27, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

RCA P52810lv will not power on


Completely dead with nothing suggests maybe a blown or open fuse--first step would be to unplug and look for a fuse--follow the power cord.

Jun 11, 2012 | RCA Televison & Video

1 Answer

I have a Sharp VC-H982 VCR. Went to turn on today and it is not getting any power. Worked fine last night. I have moved the power cord to a different receptical, still nothing. Is there a fuse that may...


Hi:
If the unit is totally dead meaning no standbye light of or nothing on the display its dark, then you may of blown the AC line fuse. This is the first thing to check the fuse is inside the unit you can trace its location by taking off the top of the VCR and tracing the pwr cord to the point where it connects to the power supply, here is where you will find the AC line fuse use a ohm meter set on continunity to check the fuse for open condintion. If open or blown replace with same voltage and Amperage rating as indicated on the board or the fuse itself. If you find the fuse is good then you have a power supply standbye voltage missing and is related to the power supply. In which case it may be cheaper to just purchase another.

May 28, 2011 | Sharp VC-H982U VHS VCR

2 Answers

Monitor dead


Check your power cables properly and make sure it is attached. Check your power button, maybe you have pressed the wrong one.

Jan 03, 2010 | Acer AL1916W 19" LCD Monitor

1 Answer

Same exact thing happened to me today with my 06 Odyssey !!!!!!!


the main switch that controls all the windows is on the drivers side it will allows the drivers window to work then allow your brain into thinking that its fine no its not always fine change it your problems will go away. its the master/main switch that is why the two back windows does not work, they does not always go bad at the same time.

Aug 19, 2009 | 2002 Honda Odyssey

1 Answer

Will not turn on


hello check the glass fuse inside the power adaptor
if not a glass fuse it will be a soldered in fuse called a wickman all the best

shaun

Aug 04, 2009 | Nintendo Wii Console

1 Answer

Power will not turn on for our wii


I suggest going to the Local Electronics/gaming store, i had this went to them and they said that one of the fuse's was burnt, Try that if not, call nintendo and kick their ***** !

Mar 14, 2009 | Nintendo Wii Console

1 Answer

Tv was working fine yesterday. got up today and nothing.


Dear,

can u do repairing or have you ever troubleshoot the issue by yourself.
if yes, then open the cover and check the continuety of the power cable because it can be the damage cable. if all of then check the fuse inside the circuit board where the main power cord goes. the must be a glass fuse. Check is it in working condition means having continuty too.
if this component is ok then u have to check the other circuitry.

regards,

Mar 13, 2009 | Sansui DTV3200 32" TV

1 Answer

2003 windstar no power past the battery ?


I would check with vom voltage at battery terminals and at starter to ground. Is possible could be a fuse or fusable link but I think the positive goes straight to starter and power distribution fuse or fusable link

Dec 15, 2008 | 2003 Ford Windstar

2 Answers

HITACHI 37PD5200 E Plasma dead.


The fuse is either open or it will have continuity do you have any standby voltages

May 14, 2008 | Televison & Video

Not finding what you are looking for?
Pioneer SX-315 Logo

Related Topics:

695 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pioneer Audio Players & Recorders Experts

 Grubhead
Grubhead

Level 3 Expert

5126 Answers

John
John

Level 2 Expert

509 Answers

T-Comtech Repairs
T-Comtech Repairs

Level 2 Expert

417 Answers

Are you a Pioneer Audio Player and Recorder Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...