I recently replaced the blades on the my Andis T-edjer. However, the blades are not operating as they should. I'm getting a dull trim. No noticeable difference. Are there any repair centers that can possibly assist me? Thanks from Georgia
If you are in Georgia there is a repair center in Atlanta called CJ Grooming Tools. You can either go to their shop or send your unit in for repair. Their phone number is 770-451-9275. If you would like to send your unit to the factory for repair or to talk with a customer service rep at Andis please call 1-800-558-9441.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Sometimes the new blades from Andis are not sharpen enough to get that clean cut. also all trimmers need to be readjusted for power and alignment, plus sharpening the blade, it look like you need a complete sharpen & service on your Andis trimmer. check out Manny's Sharpening they have a Mail Order service, the service they provide is fast and they will sharpen make all the adjustment and give your trimmer more power and the blade will cut clean. They will even adjust the blade at your request on how you want that blade to be set at. Line Ups or Fade Cuts and even shave set. Manny's Sharpening been around for over 20 years and they have a very good rating on the net.
Check it out Manny's Sharpening
hi, new blades are not the answer try replacing the blade drive assembly which is located at the drive end of the clipper and goes from side to side, as the clippers are used this part will gradually wear in width thus not moving the cutter far enough to complete a cut this will produce snagging in smaller blades and tram lines in larger blades like 7, 5, 4 and 3's. All Clipper Parts are available for these clipper repairs.
Your trimmer will need to be sent in for service to correct this problem. If you would like to speak with a customer service rep before sending the unit in you may call 1-800-558-9441. To send the unit in we recommend either UPS or Fedex Ground as you will then have a tracking number to follow the shipping process of the trimmer. Our address is Andis Co 1800 Renaissance Blvd Sturtevant WI 53177 Attn: Repair. Be sure to include your name and address inside the box with an explanation of the problem.
For the replacement of blades please visit the Andis website at www.andis.com. Choose USA, then service, then use and care. Once you are at the use and care section find your model and click on it to bring up the instruction manual.
If you are still have problems there are two service stations in Maryland as listed below. If neither of these are close to you you can send the unit into Andis for repair.