Question about Philco (R) Classic Turntable CD Shelf System

1 Answer

I have a Philco Classic ... the turntable did not work. I pulled the arm back, as suggested, and it worked! But it really drags when I try to play an LP. What now?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

What do you mean it drags? I noticed if you don't pull the arm back far enough,it will turn on,but the arm will drag foward scratching your record. Try pulling it bacl ALL the way and then it should give you no problems.

Posted on Nov 30, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Technician can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Technician (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

On my Philco Turntable CD with cassette the CD player does not close all the way. If you manually close it, it does not play


You are describing too problems, won't close all the way, could be a bad loadind belt. the second issue it will not play, the timing gear is out of sync, or the laser pickup is not functioning, you will need to take it to a service shop for assessment.

Jun 02, 2012 | Philco (R) Classic Turntable CD Shelf...

1 Answer

The turntable on my philco cd cassette and turntable unit does not turn. how to i access the belt, etc. to see whats wrong?


I had a similar issue with my Crosley turntable that I recently picked up... and after digging up the manual online all I had to do was lift up on the tone arm and move it to the right (past the holding mechanism) until it clicked, and voila, the turntable started spinning again.

I hope this helps!

Sep 18, 2010 | Philco (R) Classic Turntable CD Shelf...

1 Answer

Philco 841.205 Turntable Issues


I take it that it doesn't turn? OK two choices for you. Faulty motor, or a on/off switch that doesn't work. If you have to move the arm to start the turntable then some kind of leaver switch is either bent or broken.
I should imagine this model uses no more than a 12 volt motor. If you have no look with the switch, find the motor and take it out. Then stick a 9 volt battery on it, or lower voltage if it's only 6 volt motor. If it don't go it's bust!

Jun 01, 2010 | Philco 841205 Turntable

1 Answer

How to turn on turntable on Philco Turntable CD Player


Just pull the arm back a little bit, the turntable should then start.

Apr 20, 2009 | Philco (R) Classic Turntable CD Shelf...

1 Answer

Turntable won't spin


you need to open the under neth there is a belt that turns the turntabel one it could be the belt broken 2 it is slipping cheers peter

Apr 05, 2009 | Philco (R) Classic Turntable CD Shelf...

2 Answers

Philco turntable cd with cassette player all i get is the cassette playing nothing else works where can i get it fixed here in washington state


just find a local electronic repair shop near you
look in the phone book for electronic /electronic repar shop
i have had to repair these before and the selector chip has failed because of a resistor letting to much current and voltage go into the chip , repair cost $40-$50 depending on the dammage

Oct 29, 2008 | Philco (R) Classic Turntable CD Shelf...

1 Answer

Philco turntable CD with cassette


Most of these are blet driven and the belt is probably slipping. This is a relatively simple repair if you have the correct belt. I'm in Massachusetts, so I don't have any particular recommendations for you. The belt will cost around $10.
Dan

Mar 21, 2008 | Philco (R) Classic Turntable CD Shelf...

2 Answers

Philco 841.205 TurnTable spring and plastic armature pulled off HELP


Well it turned out that that 45 degree plastic piece DID or WAS attached to the main post. It snapped off. I super glued it back on and to each side of that very flimzy broken plastic I cut two very small pieces of wood (using popsicle sticks) and super glued THOSE to either side of the broken armature piece. Once dried I re-attached the spring and it worksd like a charm.

Oct 10, 2007 | Philco 841205 Turntable

Not finding what you are looking for?
Philco (R) Classic Turntable CD Shelf System Logo

Related Topics:

125 people viewed this question

Ask a Question

Usually answered in minutes!

Top Philco Audio Players & Recorders Experts

 Grubhead
Grubhead

Level 3 Expert

5309 Answers

jason

Level 3 Expert

905 Answers

Steven Wander
Steven Wander

Level 3 Expert

593 Answers

Are you a Philco Audio Player and Recorder Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...