- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
This only happens with DVD. This invented to keep copyright protection different in some regions of the world.
There are programs that rip a DVD and then you can burn it free of any region code. Some brands do sell DVD players without region code limitation.
Read the article on wiki about region code. The disk you try to play, comes from another country. DVD region code
Disc has been loaded upside
down. Place the disc with the label side up.
Disc region code does not
match region code of the player.
Disc type is not the correct
type to play.
Disc is damaged or dirty.
Clean the disc or try another.
Moisture may be condensed
inside the unit. Remove the disc and the leave the power on
for one or two hours.
If this not resolve the problem, you must tes the reset+clock signal for to RESET the microcontroller, unppluged the power cord by 15 minutes, and connect again. If the problem persist you have problem with the sections blocks electronic peripherifical to microcontroller or itself. Go to the repair shop TV for fix it. remember do the 6 steps befores God bless you
Hi, your problem is the laser lens, it went sour. This device is coded to read only region 1 disks, when U attempt to read other regions disks it will read them once, 2 or 3 times but then... it will stop reading any disk regardless the region they are. Regions codes were implanted on disks to control piracy, so USA has region 1, Mexico 4, Asia I believe is 3 and so on. There are a total of 6 regions worldwide, U have to get disks matching the region U are from or, better solution... get a multi-region DVD player.
power on the dvd
let it load and show no disc
open tray and enter '0' four times
region edit and region code appears with the default code
press 0 for region free and enter
region code should be 0
press pause on remote
power off and on again
The fix on the DVP3120 was as follows. I don't know if this works on 3144 - would like to know.
1. Turn on the unit 2. Open the loading tray 3. Press the "Setup" button on the remote 4. Navigate to the "Preferences" page using the right arrow key 5. Enter 138931 6. You will now see the current region code displayed 7. Use the Up/Down arrow keys to select the region required or "0" for all regions 8. Press the "Play" button on the remote