Question about Sony SLV-660HF VHS VCR

1 Answer

Mitsubishi galant cd player

After replacing my battery my cd player gave a code error. i need that code for the cd player...thanks

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 579 Answers
Re: mitsubishi galant cd player

Battery in the remote? What is your model number?

Posted on Dec 29, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Mitsubishi VCR Model HS-821V Ejects Video Cassette & gives an error code E4

Sometimes things like that are caused by the mode switch which will either need to be cleaned or replaced. It's worth looking inside for damage inside the unit. Pay close attention to plastic parts.

Nov 26, 2012 | VCRs

1 Answer

E5 code - no video. solution??

E5 relates to the heads being dirty, after cleaning do a hard reset by unplugging the machine for a few hours and then replugging. sometimes the error will not reset after cleaning unless its unplugged

Please rate my help++++Thanks for using FIXYA

Nov 25, 2009 | Mitsubishi HS-U775 S-VHS VCR

1 Answer

Need remote code for mitsubishi vcr

Need remote control for Mitsubishi HS-820V(IR) VHS recorder,any idea where I might get one


Sep 13, 2009 | Mitsubishi VCRs

1 Answer

Error code E4 on Mitsubishi HS-U576 VCR. Machine is eating tapes.

Hi, The error E4 means Reel Lock Detection.
Thanks! mannu_rakesh

Sep 02, 2009 | Mitsubishi HS-U576 VCR

1 Answer

Sony DSR error code C31:30 & C31:23

Error codes definitions are bit technical and as follows...

C:31:30 error code shows problem of No FG signal when starting capstan motor.
C:31:23 error code shows problem of No S reel signal to system control.

Above info were taken from service manual and picture of service manual can be seen below...
Need further info, let me know.


Oct 28, 2008 | Sony DSR-45 Mini DV VCR

3 Answers

Error Code: 3271


Oct 16, 2008 | Sony DSR-45 Mini DV VCR

1 Answer

Error E3 on Mitsubishi HS-U795

Try this :
If your VCR malfunctions, try the following steps prior to contacting your Mitsubishi Dealer:
1 Check the Trouble Checks below to see if there is a solution to the current problem that you are
2 If the problem is not addressed on the Trouble Checks, the safety circuits in the VCR may be in
operation, thus please try the following: (the clock setting and the timer recording will be deleted.)
1 If possible, press EJECT on the front panel and remove the tape.
2 Press TIMER RESET on the rear panel with a pencil or a ball point pen.
3 If a tape is not loaded, press POWER to turn the power on. If a tape is loaded, wait about 1 minute
until the tape protecting function is completed, then press POWER.
3 You may also try the following procedure if the above steps did not resolve the problem (All settings will
be reset to the default settings.).
1 Press POWER on the front panel continuously for about 8 seconds until the current time display on
the front panel shows "- : - -."
2 If a tape is not loaded, press POWER to turn the power on. If a tape is loaded, the tape protecting
function will work and "99" will appear on the front panel display to begin count down. Wait about 1
minute until it reaches "00" to show the tape protecting function is completed, then press POWER.
If the problem with your VCR persists, contact your Mitsubishi dealer for assistance.

Im looking for error codes.

Mar 10, 2008 | VCRs

1 Answer

Cannot eject VHS tape from Sony SLV-X811

I had a similar problem with a Panasonic VCR. It would not eject the tape and gave an error code. I found that the door does not quite fully open, so that the top of the tape hits the door and cannot eject. If I turn off and then turn on the VCR the error code disappears. Then I press the eject button and simultaneously hold the door fully open with one finger until the tape starts to eject and clears the door.

Feb 29, 2008 | VCRs

1 Answer


Hello thank you for getting back to me. No i did not get any codes for my VHS I allso was looking for the codes with my unevercal Magnavox remote. Still nothing. thanks Rita

Feb 08, 2008 | Mitsubishi VCRs

2 Answers

DVD player /video cassette recorder

pull your head out of you *** and clean the heads

Dec 14, 2007 | VCRs

Not finding what you are looking for?
VCRs Logo

87 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sony VCRs Experts

Andy Fraser
Andy Fraser

Level 2 Expert

129 Answers

Cindy Wells

Level 3 Expert

4723 Answers

Pieter Vleeshouwers

Level 3 Expert

1333 Answers

Are you a Sony VCR Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides