Question about Mitsubishi VS-45607 45" Rear Projection Television

1 Answer

Shaking screen I turn my TV on and for about and hour the screen shakes, once its warmed up the shaking stops. This problem continues again once I've turned the TV off and back on.

Posted by on

  • Anonymous Mar 24, 2014

    turn tv on works for a few minutes than gets dark and picture shakes

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 934 Answers

Check the 9v regulator Ic2p01 on the signal board for correct regulation 8.9 to 9.1 volts. If voltage at the output is under 8.9v, replace the regulator Ic. Always replace C2p05 100 Ufd 16 V on this set and that should take care of the shakes but you may want the tech to go ahead and ESR some of the other troublesome caps throughout the Tv. He'll know what you mean. Many of the 100mf caps replace automatically. Several others will have a questionable ESR and should be replaced. Caps are inexpensive, but probing with an ESR meter is somewhat labor intensive so you miht discuss with the tech just how far you want him to go testing for bad caps.
A Mits is a great Tv and this repair is clearly worth it..
Bill

Posted on Dec 19, 2007

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Got a mitsubishi eclipse gt 2003 manual transmission. When the engine is warm and after like 1 hour of driving the rpm drops at 600rpm when stopped on a red light etc. and the car shakes. What could be the...


This could be due to your o2 sensor not giving a proper reading and offsetting the air/fuel mixture causing a low idle. Most vehicle have a loop setting so when the vehicle starts up it will run the air/fuel mixture at factory setting then once the temp senor heats up the o2 sensor will kick in and change the air/fuel mixture. You could also have an exhaust leak before your o2 sensor.

Oct 19, 2014 | Cars & Trucks

1 Answer

Picture shakes


sounds like caps dying on power board

Nov 28, 2012 | Samsung UN55B6000 54.6 in. LCD HDTV

1 Answer

Ford f250 diesel 4x4 truck problem


check the drive shaft joints for worn/siezing

Feb 20, 2018 | 2004 Ford F250

4 Answers

Samsung Fax Machine keeps trying to warm up


I have similar problem, but it makes clicking sound also without a toner. And printer is powering off and on continuously. On the display there are some bars, nothing readable. After a minute or so it says Warming..., than it goes off, and so on and forth. Printer is in use on a daily basis.

Feb 24, 2010 | Samsung SCX 4521F All-In-One Laser Printer

1 Answer

The bottom half of my screen is shaking like a "non" TV channel.... I restarted it, and turned it off and back on again and it continued. The shaking occurs every 2 seconds and is spreading higher now. ...


If you can.. Plug a Desktop Monitor into the Serial Port of the Laptop..You do This To See If It Shows Same Thing Onto A Different Screen.. If It Does, You Are Having Video Issues.. Which Were Most Likely Caused From Overheating Issues..
If It Shows Normal On The External Monitor, Yet Still Does Same THing On The Laptops Screen, Then You Have 1 of 2 Issues... Either You Need To Replace The Display Due To A Faulty Circuit Board On The Backside Of The Screen... Or Your Display Cable Is Loose And Needs To Be Fully Plugged Into It's Port, Or The Display Cable Is Failing..

Nov 15, 2009 | Computers & Internet

1 Answer

I have a Mazda MPV 2004 van that recently had the check engine light come on. Over time, the van started to **** and shake whenever idling in Drive. It shakes for few seconds, idles smoothly, then starts...


i would try to replace the maf sensor first because ive seen that a few times on ford and mazda vehicles (same vehicles really with different names) and also clean the throttle plate at time u change the maf.

Jun 18, 2009 | 1999 Pontiac Firebird

1 Answer

Screen shakes / jumps vertically on my Sony KP-51HW40


The jitter is called a vertical sync problem. The problem is on the "A" board. It can be replaced or rebuilt but will be quite expensive to service.

michtech

Feb 09, 2009 | Sony KP-51HW40 51" Rear Projection...

2 Answers

Screen flickering and shaking


My suggestion 2 U is that maybe your TV is the 1 acting up. not the PS3

Jun 09, 2008 | Sony Playstation 3 (PS3) Console

Not finding what you are looking for?
Mitsubishi VS-45607 45" Rear Projection Television Logo

Related Topics:

491 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Televison & Video Experts

matt martin
matt martin

Level 3 Expert

1230 Answers

The Knight
The Knight

Level 3 Expert

75843 Answers

Jaime Hernandez

Level 3 Expert

2336 Answers

Are you a Mitsubishi Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...