Question about Hotpoint Aquarius WD640 Front Load Washer/Dryer

1 Answer

Dryer not working

I've had my WD640 for 3 years with no issues. Its gets light to regular use, 3 washes a week but in the last 2 days the drying cycle has stopped working.
I've run it with programme "M" but the drum doesn't heat up at all.
Is the heater gone? Is it an easy fix? Gonna cost much?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has achieved Level 3.

  • Master
  • 619 Answers
Re: Dryer not working

The sensor are malfunction/ test the sesor w/multi tester test both terminal if does respond or reading sensor open/ mostly malfunction of drier are sensor /the element will not glow or hot if sensor is the problem.

Posted on Jan 05, 2008

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Summit washer/dryer combo quit drying. Repairman came and replaced themafuse and thermastat kit. Shortly thereafter, the dryer cycle timer would indicate 10 minutes left and never clock down. The dryer...

summit washers are prone to board failures i would say that is where the fault lies . thermafuse fuse means it has been overheating. means it can damage other parts. thermostat would thing that has just worn out thermostat can go if the unit overheats. under line is an electrical fault. but like i've said it is a common fault with this make and others. the main boards can only handle around 50c in temp after that they start to over heat and cause problems. the faults started when they moved the main board from the bottom to the middle.

Oct 25, 2013 | Summit SPWD1470C 24 Inch Washer Dryer...

4 Answers

Frigidaire Front Load Washer FAFW3574K - Is this a good washer, and how long should I expect it to last?

There are many things that can facotr into the life of a washer.
How many loads a week do you do?
What are the size of the loads?
What is the quality of the water?

Under many circumstances you can reasonably expect your washer to last 8-10 years.
The factors mentioned above can change that higher or lower depending mostly on your useage..


Mar 10, 2010 | Washing Machines

1 Answer

Dryer not drying in one cycle. takes multiple cycles do dry one medium size load. the machine is less than a year old and we clean the filter after every load. checked the vent hose and its clear with no...

HI, Check the following to address this issue further.

Note: Normal drying time for a dryer is about 45 minutes (some may take up to an hour).

1. Venting
Make sure the dryer vent hose, as well as the rest of the vent duct, is not clogged.

Unless regular maintenance is performed, chances are there is a lot of lint accumulated inside the dryer. This might affect the drying time and could be a fire hazard. Make sure to have your dryer cleaned regularly. Because this might involve taking most of the dryer apart, it is recommended to have a qualified appliance repairman perform this task.

2. Thermostat
There are a couple of cycling thermostats inside the dryer. If one of them breaks down, it might affect the dryer's performance. Replace the defective thermostat. These thermostats are located in the dryer vent duct and sometimes mounted on the blower assembly as well.

Nov 23, 2009 | Whirlpool Estate TAWS750PQ 27-Inch Washer

1 Answer

Water fills the washer during spin cycle

defective timer...a model # should be under the lid...or open dryer door and on front dryer panel right hand corner..onthejob

Jan 16, 2009 | Whirlpool LTE5243D Top Load Stacked...

1 Answer

Spin cycle lasts indefinately

the spin cylce in washer, did not shut off?soundslike an issue with the timer itself, no servicing htetimer strictly replace, as far as teh time in the dryer, i would check for clogged/kinked dryer vent, biggest issue with any dryer, innadequate vent

Nov 25, 2008 | Kenmore 98702 Stacked Washer/Dryer

3 Answers

Splendide 2000 doesnt work at all on wash

I have exactly the same issue. The door normally locks, but doesn't do anything on wash.

Jul 29, 2008 | Splendide 2000S Vented Washer/Dryer

2 Answers

Bosch classixx 1000 washing machine - stops on spin

Washing machine stops at the spin cycle - light flashes. Have to drain water out manually. Happened last week and was then able to run an empty rinse cycle. Machine worked normally for another week. Same problem today but have had to drain water manually from the drum after trying an empty 90 wash and rinse cycle (both stopped on the Spin and flashed). Any ideas? Thanks. x

Apr 29, 2008 | Bosch Classixx WVF 240S Front Load Washer...

2 Answers

LG WM-3677HW dryer cycle does not dry and lasts for 3 minutes

Press "end of cycle". Plug off the wall. Code can be an indication of several issues. The most common cause is over-sudsing in the machine. Overloading the wash with too much laundry may also cause the LE error code. Lastly, a breakdown in the signal between the microprocessor and the motor may cause that error code. This can occur if there is a loose wire, see that all wires are tightened..........
And rate me pl ...........if helped.

Oct 23, 2007 | LG WM-3677HW Front Load Washer / Dryer

2 Answers

Problem with our washer/dryer

sump/filter is blocked instead of flushing on dry cycle is filling as not pumping well. ring hotpoint to reorder pts cheaper then anyone

Jan 06, 2007 | Hotpoint Aquarius WD63 Front Load...

4 Answers

Zanussi jetsystem Turbodry 1200

It appears that you may have a faulty door interlock or a faulty PCB. pcb is not really a DIY job as some boards require proramming on certain versions. Regards Advisor

Oct 30, 2006 | Zanussi FJS1225W Front Load Washer

Not finding what you are looking for?
Hotpoint Aquarius WD640 Front Load Washer/Dryer Logo

Related Topics:

106 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hotpoint Washing Machines Experts


Level 1 Expert

5 Answers


Level 1 Expert

47 Answers


Level 3 Expert

2963 Answers

Are you a Hotpoint Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides