Question about Whirlpool Ultimate Care II LSQ9564J Top Load Washer

1 Answer

Washing machine hwen i fill the washing machine with water the water runs out immediately

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert who has answered 200 questions.


    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 249 Answers
Re: washing machine

The water outlet hose is down too low!left it up!good luck,..eire

Posted on Dec 18, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Water drain out immediately while filling the washing machine

you should check 2 things the drain pipe should be higher than the drum or there is some dirt in the thin pipe of the pressure switch try to blow air in it in order to clean it

Feb 10, 2014 | Simpson Esprit 750 Top Load 7.5kg

1 Answer

Washer fills then drains immediately

Motor plug faulty. Remove and check for burnt wires.

Dec 08, 2013 | Zanussi ZWF1430W Front Load Washer

1 Answer

Kitchen sink hole fills up with water when using the washing machein

After washing cycle all the water flows immediately from tub to drain pipe. If the flow capacity of sink is slow sink hole fill up with water .
Connect washing machine drain to proper place for drainage.

Oct 05, 2013 | Washing Machines

1 Answer

Washing machine begins the wash cycle going immediately to the agitate cycle, without filling up with water first.

water will not stop running into drum unless shut off at faucet does not happen all the time and wife can't find her rubber boots

Apr 26, 2009 | Washing Machines

1 Answer

Machine is not filling with water.

the solution is so simple, you have to open it
and clean the plastic pipe that runs from the tub to the load switch, sometimes gets dirty with detergentes and mud.

Mar 07, 2009 | GE Profile WPRE6100G Top Load Washer

1 Answer

Maytag performa washer hot water runs continuously

Littleone.. please check your instructions.. some washers now dont need Hot water connection to them...they heat their own as part of the efficiency settings on the wash programmes themselves!

Regards Faggly

Mar 19, 2008 | Whirlpool Estate TAWS750PQ 27-Inch Washer

1 Answer

Washing machine

i had the same problem. but alas i had to remove pump and found my girlfreinds panties in pump. but it was easy to do. have a lot of towels handy if you do it.

Jan 28, 2008 | Whirlpool Ultimate Care II LSQ9549L Top...

1 Answer

Whirlpool washing machine

You could have a hole in the pump. Check to see where the water is coming from after removing the cabinet, or tip the machine back.

Jan 09, 2008 | Whirlpool Ultimate Care II LSQ9564J Top...

1 Answer

Maytag performa washer hot water runs continuously

dudett, uplug the washer and turn the water valves on. If the washer is filling with the washer unplugged the valve is bad. Part number 22001196. Not a hard job. If you need help installing, just e-mail the cat here at back.

Feb 19, 2007 | Maytag Performa PAV2200

Not finding what you are looking for?
Whirlpool Ultimate Care II LSQ9564J Top Load Washer Logo

Related Topics:

27 people viewed this question

Ask a Question

Usually answered in minutes!

Top Whirlpool Washing Machines Experts

Dan Webster
Dan Webster

Level 3 Expert

8147 Answers

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

Mike Cairns
Mike Cairns

Level 3 Expert

3053 Answers

Are you a Whirlpool Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides