Question about Ryobi 30 Cubic Centimeter Curved Shaft Gas Trimmer

1 Answer

I have a 31 cc ryobi weed eater start for about

I have a 31 cc ryobi weed eater start for about 40seconds and quit

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 135 Answers

I think a new carburetor kit and a good carburetor tune up is in order my friend. Sounds like it's starving for gas. If it bogs down after warm up when you throttle it, then yes it needs a carb tuning. The L screw is the low side screw and should be turned in lightly until it seats then back it out one and quarter turns (1 1/4). The H screw is your high speed screw. Also, turn it in lightly until it seats, then back it out approximately a 3/4 turn. With these settings the unit should start and may even stay running. Again, if it bogs when throttled, while running turn the L screw out a little more maybe only 1/16th of a turn and then try it again. If it does rev then you'll have to adjust the H screw in about a 1/16th of a turn. But make sure you only do this after the engine has warmed up.

Hope this works, good luck
Skidooer

Posted on Oct 03, 2009

Testimonial: "i,ll try this thanks a lot "

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ryobi electric hybrid weed eater quit working.


are there weeds stuck under the trimmer head causing it to work too hard perhaps and even short cords if not heavy enough will cause problems and burn out the motor

Jul 18, 2015 | Ryobi Lithium Ion 18 Volt 18v Cordless...

1 Answer

Ss30 ryobi weed eater fuel ratio


I work with weed eaters and mowers. Weed eater fuel ratio is normally a 40:1 ratio. That usually all weed eaters fuel ratio.

Sep 11, 2012 | Poulan/Weed Eater No. Te475 952711797 17"...

1 Answer

Petrol weed eater will not start. Alomost starts


Hi Mark, I own a shop, we will not work on ryobi, have you gotten 2 seasons out of it? If so thats probably as good as it gets. But you can check carb settings. In the USA they come with limiters on the adjustment screws, not too much you can do(break them off) back your adjustments counter clockwise 1half turn.

Dec 20, 2010 | Ryobi Three Trimmer Combo

1 Answer

Ryobi weed eater head won't spin


Sounds like the clutch has taken a long trip south. If the clutch pads are not wore out, try some wd40 on the pad hinges.

Apr 27, 2010 | Ryobi Garden

1 Answer

My husband took his Poulan Pro 31 cc weed eater/trimmer apart and now needs an engine diagram to put it back together. Where can I get a downloadable one ?


Go to the Poulan web page http://www.poulanpro.com/node6556.aspx and enter the model number of the string trimmer. If the trimmer is a Weed Eater brand (owned by Poulan) then go to this page http://www.weedeater.com/node6507.aspx. I think you can also locate older model manuals in their archives.

Apr 10, 2010 | Poulan Garden

1 Answer

Ryobi petrol weed eater


SOUNDS LIKE YOU MAY NEED TO REPLACE THE FULE LINES THAY DO GET BAD OVER TIME

Dec 08, 2009 | Ryobi Garden

1 Answer

Clutch removal on 31 cc weed eater


Break the engine away from the shaft on the shaft side. I think 4 bolts/screws. Once you have that open you will seethe part that goes over the shaft. To take it off, hold the part with one hand and remove a screw in the center of the part using a #15 TORX screwdriver. Take off the part and under it is the clutch. Good luck...Lee

Sep 05, 2009 | Ryobi Garden

1 Answer

My Ryobi weed eater loses power at working speed after 5 minutes.


you need to replace fuel filter inside the fuel tank . fish it out with and empty tank using a coat hanger and a small hood bent on the end.filters are around $9.00

Aug 21, 2009 | Ryobi 30 Cubic Centimeter Curved Shaft Gas...

Not finding what you are looking for?
Ryobi 30 Cubic Centimeter Curved Shaft Gas Trimmer Logo

815 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ryobi Garden Experts

Nick Olsen

Level 2 Expert

183 Answers

Roland W VanLue
Roland W VanLue

Level 3 Expert

486 Answers

Doctor PC
Doctor PC

Level 3 Expert

7733 Answers

Are you a Ryobi Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...