Question about Whirlpool Duet 7.0 Cu. Ft. Super Capacity Plus Electric Dryer

1 Answer

My dryer wont comeon at all the panel does not light up at all

It has been working fine, i put a load in to dry last night and this morning it was still we. no error message . the inside light is on, but the panel lights are faint but .wont start or reset or anything.....

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Vice President:

    An expert whose answer gotĀ voted for 100 times.

    Sniper:

    An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

  • Expert
  • 107 Answers

This is a very common problem with this dryer. It could be one of three things. List below is in order of probable cause:
1.) Bad connection between the interface & Control boards.
2.) Interface board. (Front Bezel with all the buttons)
3.) Control board. (under metal cover top left side of unit)
If it was me unplug unit. Remove 3 each screws on back of unit that hold the top on and remove top. Remove screws and open silver box on top left side. With a small screw driver carefully push in on lock tab and pull 2 each flat cable assembly from control bd. Remove silver crossbar at the top near the from 2 screws. Open door pull out and up on front input display bezel carefully. Same process as before remove all cables and reinstall them back in there original location. Then reassemble in reverse order.
Turn power on this should fix the problem.
If it does not then replace the interface board if that does not work then the control board.
me.

Posted on Oct 27, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Dryer will not operate


We are sorry to hear of the problem with your Whirlpool appliance. We would recommend having a local certified technician in your area properly diagnose and repair the issue you are experiencing. Please email us at Whirlpool_Digital@Whirlpool.com with your name, phone number, address and the model and serial number for your dryer.

Apr 04, 2017 | Whirlpool GEW9250P Electric Dryer

1 Answer

Samsung DV210AGW/XAA Dryer, drum wont turn nor heat up


hi all, thanks for your comments. to note, it's my dryer not my washer so the suggested solutions wont work. Also, forgot to note, the unit is only 14 months old and just out of warranty. What I've done so far:
- vacuumed the filter
- striped the dryer, meaning removed top. front and small exhaust panel in the back
- vacuumed everything
- checked the belt, tight, not loose, broken or off the roles
- child safty not enguaged, toggled it anyway to be safe
- the checked micro switch next to belt by motor, not engaged
put it all back, turned on with nothing, tried every setting in auto and manual tied high to low temps and times, the time is noted, such as 40 min, but does not time down, over time, the unit sound the I'm done tone, if left as is, continues to chime then end like it did something. all along, the drum never rotated nor did it heat up.
Does one impact the other, such as if the drum does not roll then the heater wont start or vise-a-versa. Could the control panel have taken a hit or are there sensors that might have shut down to prevent the unit from starting are there fuse's that I didn't see that might have been tripped.

Jan 04, 2013 | Samsung Washing Machines

1 Answer

Hello,I just picked an electric ROPER dryer last night.I assembled it plugged it in and it worked fine.This morning I put a small load of laundry in it and it worked fine.I then put in a second load and...


Hello,

The most likely part that has gone out is the thermal fuse. What will make that go out so quickly is a blocked vent causing excessive heat build in dryer. Did the dryer that this new one replaced havea similar problem of not starting or perhaps it ran but took forever to dry a load of clothing? if that was the case the venting caused the problem with both old and new dryer

Good luck
I hope this helps,if it does please give me a 4 thumbs up rating

Gene

Jul 30, 2011 | Roper Dryers

1 Answer

Last night I dried multiple loads of laundry . . . the dryer worked fine. This morning when I pressed the button to turn it on nothing happened. The control panel is completely blank, as if the dryer is...


Normal 0 MicrosoftInternetExplorer4 /* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-parent:""; mso-padding-alt:0in 5.4pt 0in 5.4pt; mso-para-margin:0in; mso-para-margin-bottom:.0001pt; mso-pagination:widow-orphan; font-size:10.0pt; font-family:"Times New Roman";} Hi,

There can be many reasons why your dryer will not start or turn...

The most common causes are the belt breaking or jumping off, or the motor going bad...

Here are a couple of tips that I wrote will help you to figure out why your dryer will not run...

Dryer Repair - The Dryer is not Turning

Dryer Repair - The dryer will not start


heatman101

Aug 24, 2010 | Kenmore Elite HE4 Electric Dryer

1 Answer

Dryer lights works, but when the start button is pushed the drum does not spin. the timer shows the minutes counting off, but no spinning. the dryer worked yesterday, but no today. dryer is a duet...


I am having the same problem. Dried towels last night. This morning, I loaded it, turned it on, it did not lock the door or start drying (spinning) but the timer started counting down. I pressed Cancel twice, unplugged it for a few minutes then tried again. Problem still exists. Any suggestions?

Aug 04, 2010 | Whirlpool Duet 7.0 Cu. Ft. Super Capacity...

1 Answer

Tv wont turn on worked fine last night


If there is no power at all, then the problem is likely the power supply unit.
The PSU must be tested, then eventually replaced.

May 30, 2009 | Spectroniq PLTV3250 32 in. LCD TV

1 Answer

My Performa dryer stopped working.


Unplug the dryer.
Replace the thermal fuse and high limit switch located at the heater element.
The parts come as a set.
Raise the top lid of the dryer. The parts are at the back left side.

Mar 10, 2009 | Maytag Performa PAV2200

1 Answer

Kenmore 600 Series gas dryer


trigger broken dryer will not turn on. I need a replacement. Where can I buy this part.

Nov 02, 2008 | Dryers

Not finding what you are looking for?
Whirlpool Duet 7.0 Cu. Ft. Super Capacity Plus Electric Dryer Logo

230 people viewed this question

Ask a Question

Usually answered in minutes!

Top Whirlpool Dryers Experts

Dan Webster
Dan Webster

Level 3 Expert

8220 Answers

Tim Whalen

Level 3 Expert

3072 Answers

yadayada
yadayada

Level 3 Expert

75051 Answers

Are you a Whirlpool Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...