My dryers isnt working the status is in control locket

try unplugging for a couple of minutes and it should reset to factory settings.

1. Press and hold for 3 seconds the "Control Lock/Unlock" button on the control panel to lock the control panel.
2. Listen for a double beep and observe the "Control Lock" status light is lit when the control lock is in effect.
3. Press and hold for 3 seconds the "Control Lock/Unlock" button on the control panel to unlock the control panel. The "Control Lock" status light is goes out when the control panel is unlocked.

the gas system isnt igniting

1. Press and hold for 3 seconds the "Control Lock/Unlock" button on the control panel to lock the control panel.
   
2. Listen for a double beep and observe the "Control Lock" status light is lit when the control lock is in effect.
3. Press and hold for 3 seconds the "Control Lock/Unlock" button on the control panel to unlock the control panel. The "Control Lock" status light is goes out when the control panel is unlocked.
   

You don't give a model number, is this applicable? Select and hold END OF CYCLE SIGNAL for 3 seconds until the CONTROL LOCKED Status light turns off.

Try pushing and holding the 'End of Cycle Signal' button for 4 seconds. Let me know if that works.
Thanks!

Try holding in the "End of Cycle" button for 10seconds

is the other lights DIM(partially lit)?
If so it could be one of the following.
1.) Intermittent ribbon cables between the control board and the Interface board (one with the buttons) Reseat all four cables.
2.) faulty control board.
3.) faulty Input board.

To enable the control lock feature:
Press and hold the CYCLE SIGNAL button for 3 seconds. The
CONTROLS LOCKED icon lights up, and a single beep tone is
heard. To unlock, press and hold the CYCLE SIGNAL button for
3 seconds. The indicator light turns off.

If you need further help, I’m available over the phone at https://www.6ya.com/expert/craig_3fa289bf857b1a3c

bad control board.