Question about Biostar P4M800-M7A Motherboard
Ok when i turn on my computer all that happens is the fans and disk go and the light stays red and doesnt flicker or change and it wont boot up.
Ive tried everything that i could think of
Unplugging everything and plugging it back but still nothing
Letting it lose all of the charge stored up.
Why wont my computer boot up?
Is the motherboard fried?
I had exactly the same problem.... waste hours on it. I solved it by clearing the CMOS. Pins 1 and 2 on JCMOS1 are closed in normal operation mode. Move the jumper to pins 2 and 3. I then pressed the power button a few times (the motherboard will not respond to the power button at all when it is configured to reset the CMOS), but I don't think pressing the power button is neccessary. After about 30 seconds, put the jumper back on pins 1 and 2, and power up. When I did this the motherboard responded finally. Hope it helps! :D
Posted on Mar 02, 2010
The motherboard isn't the problem, it seems something is conflicting with another thing. If your using IDE (the buttload of pins on a thin long cord) you might need a cord that has 2 wires that go to the same pin. They usually are faster anyways. Get a new set of IDE cables then. Or your ram is malfunctioning and you need some new sticks of some. The last ones could be that your processor is fried and well you figure that one.
Posted on Sep 27, 2009
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Tips for a great answer:
Oct 09, 2010 | Biostar P4M800-M7A Motherboard
Dec 08, 2009 | Biostar P4M800-M7A Motherboard
Sep 30, 2009 | Biostar P4M800-M7A Motherboard
Sep 06, 2009 | EliteGroup P4M800-M7 Motherboard
Jun 06, 2009 | Biostar P4M890-M7 Motherboard
Dec 17, 2007 | Biostar P4M800-M7A Motherboard
525 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: