Question about Air Purifiers

5 Answers

Need your help

I have a Kenmore Electric Air Cleaner Modle # 85264 the other # that is on the back is B1100341 I have tried the service center for Sears and was put on hold for over 40 min and still noone came back to help. So here goes this Air Cleaner will run for about 30 to 40 min it makes a electrical buzzing noise than it shuts its self off. On the frount it blinks clean cell now and the button blinks as well that says check cell I can not find any info on this item at all so I know what is wrong with it. I have taken everything out and have cleaned it and made sure everthing was dry what is wrong with this thing HELP thank you.

Posted by on

Ad

5 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I have the same one. I held down the ON button and the CHECK CELL button for about 40 seconds (everything I read said 5-10 seconds... which did nothing for me.)... Just hold them down at the same time for a short bit.. should kick right on. Good Luck!

Posted on Jul 26, 2013

Ad
  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Lol you all are funny,all you have to do is hold the button down to reset it,that is just telling you it needs cleaned

Posted on Nov 10, 2010

Ad

It could be that the unit is wet or not properly dried. theyre set up not to work if something is wrong with moisture. try cleaning and drying the cell properly.

Posted on Oct 25, 2008

  • danny180000 Nov 10, 2010

    lol you all are funny,all you have to do is hold the button down to reset it,that is just telling you it needs cleaned

×

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 75 Answers

It sounds like the board fried. I would recommend buying a new one of a different brand. Aerus Guardian Air is the only class2 medical device approved by the FDA to actually clean air.

Posted on Jan 19, 2008

  • danny180000 Nov 10, 2010

    lol you all are funny,all you have to do is hold the button down to reset it,that is just telling you it needs cleaned

×

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Wireing Schematics for power supply board of Kenmore C347-32953 air purifier. Not sure if connection P4N is ground (black wire) or does it go on connection P1L beside it.

Posted on Dec 20, 2007

  • danny180000 Nov 10, 2010

    lol you all are funny,all you have to do is hold the button down to reset it,that is just telling you it needs cleaned

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do access the main motor of the linx BH50010


Hello m4fnli! You can disconnect the power nozzle by pressing the nozzle release button on the back of the nozzle and pulling the nozzle from the body of the cleaner. The handle can be disconnected by removing the handle screw. Assembly beyond this point is not recommended. Check that your brush roll end caps are not worn. If they are, this can cause the vacuum to be noisy. If you think there is something in your motor we recommend you take your cleaner in to an authorized service center for repair. I have included a link where you may go to locate the nearest service center to your zip code. Hope this helps!

Service Center Locator

Oct 24, 2014 | Hoover BH50010 Linx Cordless Stick Vacuum...

1 Answer

Hoover electrical diagram


Hi David. We recommend you take your cleaner to a Hoover authorized service center to have the motor on your C1810010 repaired or replaced. Follow the link below to find a service center nearest you. Thanks!

Service Center Locator

Aug 01, 2014 | Hoover Commerical C1810-010 Conquest...

1 Answer

Why is my retrieval tank light on when its empty hoover f8100900


Hi Tara! Try removing the dirty water tank and replacing it. If the dirty water tank is seated properly, you may have an issue with the sensor on the cleaner. We recommend taking the cleaner in to a Hoover authorized service center. Please follow the link to locate the nearest location to you. Thanks!
Service Center Locator

Jul 15, 2014 | Hoover F8100900 Platinum Carpet Cleaner

2 Answers

How do I change the filter on the Kenmore 335?


According to the Owners Manual, here's what you need to do,

1.Turn the air cleaner OFF and unplug it from the power outlet.

2. Carefully lay the unit down on a flat surface with the Front Grille facing up.

3. Gently push in on Release Buttons on both sides of the unit, pull Front Grille out and away.

4. Remove and discard used HEPA filter.

5. Remove any plastic protective wrapping and from the new HEPA filter.

6. Set new HEPA filter into the air cleaner.

7. Install the Front Grille by engaging its tabs into the bottom slots on the unit. Then swing grille up and gently push in top to snap into place.

8.Turn the Air Cleaner upright and plug it into an outlet for
operation.

Hope this helped you. Please let me know. Thanks

May 04, 2011 | Kenmore 335 CADR Air Purifier

1 Answer

Have Kenmore 85501 Air Cleaner. Unit will not restart after power failure. Send unit to Sears Service Center but they declined to fix unit. Tried to hold timer and function buttons for 5 seconds and...


Turn the Master ON/ OFF Switch to OFF and unplug the unit. Wait 12-15 minutes and plug the unit back in. Turn the Master ON/OFF Switch to ON and set your controls. The 12-15 minute timeout should have allowed the unit to reset itself.

Apr 16, 2011 | Kenmore EnviroSense 85501 Air Purifier

1 Answer

Need instruction manual for kenmore 83250 air purifier


http://www.managemylife.com/mmh/owner_manuals/19013/KENMORE-Air-Cleaner-L0801124

Aug 05, 2010 | Kenmore 83250 Air Purifier

1 Answer

Kenmore model 85264. Cleaned the filter only after 4 days use! It is dry. reinstalled and "check cell" light is still on. Pressing it does not reset it. Unit will not work. Filter is installed correctly.


you have to hold in the button until it resets.if the unit does not turn on you have to hold the middle button(on button)until it turns on....takes 5 to 10 seconds

Dec 14, 2009 | Kenmore Air Purifiers

3 Answers

Users Manual for Kenmore HEPA Air Cleaner Model No 85244


I have an kenmore air purifier and cannot locate where to find a replacement filter or manual for it? Can you help. It is Model # D42M32957

Apr 06, 2008 | Kenmore 85244 Air Purifier

2 Answers

Kenmore 85264 Electro Static Air Cleaner


I would recomend calling the 800 number to answer that question. I have this unit too and the instructions do NOT say to soak in Amonia and Vinegar! Good luck with that!

Mar 15, 2008 | Air Purifiers

Not finding what you are looking for?
Air Purifiers Logo

Related Topics:

523 people viewed this question

Ask a Question

Usually answered in minutes!

Top Air Purifiers Experts

Marvin
Marvin

Level 3 Expert

82322 Answers

Michael Youngman
Michael Youngman

Level 2 Expert

235 Answers

Brad Brown

Level 3 Expert

17473 Answers

Are you an Air Purifier Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...