Question about SuperMicro (SYS-5014C-T) (SYS5014CT) Server

1 Answer

Super Micro server error beeps

This server has started today to give a continous set of beeps .

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 131 Answers
Re: Super Micro server error beeps

Check the ram and VGA card if not integrated.

Posted on Jan 03, 2008

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Dell PE 1800 showed one SCSI 73G non critical state on a RAID 5 array of 3 disks. Shutdown the server, removed the SCSI disk and booted, server booted but continous beep sound, trying to rebuild the array...

Hi, try to renew the drivers and firmware from here:

Continuous beep related to ram ,try to remove ram and insert it, and if u still get beep change your ram.

Continious beeb sound is ram or cpu failure. Is the cpu fan spinning ??
If not the cpu is over heating.
Try to remove the ram modules and clean the contact points
with a piece of paper. Be very carefull when you do that !!!!!
And blow the dust out of your server, with a high pressure can.

Hope this was helpfull.

Mar 28, 2011 | Dell PowerEdge 1800 Server

1 Answer

Acer server continous beep sound

check if the memory of your server is connected properly or replace new memory for your memory... :))

Feb 23, 2011 | Acer Altos G700 Server

1 Answer

Getting error message on ibm x3400 Fatal Error Controller Monitor Failed Controller Not Started

dear sir in my server IBM X3400 has a problem due to RAM it might be corrupted or out of order bcause system gives continues beep when i change the RAM with HCL 1 GB DDR2 (Previous RAM was also 1 GB) it gives error:
waiting for controller to start
FATAL ERROR: controller kernel self test failed
<< press any key to continue>>
please solve the problem

Oct 28, 2010 | IBM x3400 Server

2 Answers

Server making continual beeping noise......

Sounds like one of two errors - either one of the power supplies has died (not sure if the 1800 has redundant power supplies or not) or a drive in the RAID array has failed. Most likely it's the drive. Run the Dell Server Administrator tool to check the health status of the array, sounds like you need to replace a drive. Most RAID systems fail if you lose more than one drive, so I'd replace that drive ASAP.

Nov 09, 2009 | Dell PowerEdge 1800 Server

1 Answer

PowerEdge 1600SC long beep and hang

check the Cmos battery. or levae pluged in over night and then check setup setting you battery went dead

Oct 12, 2009 | Dell PowerEdge 1600SC Server

1 Answer

I have a MPC NetFrame 620 server . It bagan to

replace with a new card. The beeps are indicitive 0f failed hardware 2 beep 2 beeps = video card series of 3 beeps keyboard ,malfunction etc etc so whichever card now gives you one long beep you had better start there.....

Jul 28, 2009 | Computer Servers

1 Answer

HP Proliant ML370 Server i have problems solving this server problem. When you turn on the server it tries to initialize and come up. But after a while it gives a beep sound, this sound is like that of a...

Remove all the cards except dispaly from the slots,disconnect all  hdds and start the server in minimum hardware and check.reset bios .Is there any LEDs in the mother board is glowing amber or red colour??Please try these diagnostics.

Oct 29, 2008 | HP Compaq ProLiant ML530 Server

1 Answer

No DHCP or proxy DHCP were received

Sounds like a memory error. Have you tried to open up the box and reseat or replace the memory?

Oct 22, 2007 | Acer Altos G710 Server

1 Answer

Bios upgrade error

re-install the old bios. evidently the new flash bios is not compatible with your machine.

Sep 11, 2007 | IBM Netfinity 5500 M20 4RY (86624RY)...

Not finding what you are looking for?
SuperMicro (SYS-5014C-T) (SYS5014CT) Server Logo

Related Topics:

1,543 people viewed this question

Ask a Question

Usually answered in minutes!

Top SuperMicro Computer Servers Experts


Level 3 Expert

5660 Answers


Level 3 Expert

18258 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a SuperMicro Computer Server Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides