Question about The Times Case Corporation Tractors International Harvestor

2 Answers

580 Case SK Backhoe has got so it will only start with starting fluid and run if I keep the RPM's above 1000. It has always started first crank. Seems like fuel flow. Change filters? What could my problem be.

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

Change filters, and clean the inside of pipes from tank to injectors, use a thin peice of wire to do this

Posted on May 19, 2010

  • Arneexcavati Jan 29, 2012

    I have a 98 590super l it won't start cold without starting fluid after starting it will run 4-5min then act like its running out of fuel I will try cleaning the lines out hope it works tough having a machine I can't use

×

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Easy start becomes addictive for engines if it comes to using this you have a problem that your preventing finding a solution

Posted on Jul 13, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1995 k1500 5.7 engine stalls below 1000 rpm must use starting fluid to restart


Check the fuel pressure from the fuel pump and be sure the fuel filter is not plugged. Sounds as if you might have a bad fuel pump.

Jul 05, 2014 | 1995 Chevrolet K1500

1 Answer

1990 supra, cranks, fuel pumps, but does not start


basics, always works. they are.
1: good engine?, (compression over 150psi cranked w.o.t)
2: good spark , got spark to all cylinders?. (a simple test)
3: fueling good. (not too lean, not flooding)???
from 1920 to now, all cars running on gasoline.

i can advice a simple test for each, non are complex. or costly .

if spark is good, and test fuel fails (spray)?
i bet you skipped #1 ,

here is a guy running a gas motor with no fuel in car. period

see?
http://www.youtube.com/watch?feature=player_detailpage&v=HhXwVhYfPm8#t=141s

he is a human carb. here.
just keep eyes away from the induction ports , in case it backfires.
dont 1000 of times by me.

one other tests is to (EFI) is to kill EFI (pump relay pull)
and start car on test fuel.
this helps prove engine was flooded and runs. like above.
also the opr.guide told you to clear floods with
WOT, wide open cranking, this tells tells the ECU to cut fuel 100%
to clear any flood, this works on all cars.

Feb 11, 2014 | 1983 Toyota Celica Supra

1 Answer

I have a case 580 backhoe and when you push the clutch down and try to put it in forward or reverse it grinds and wont go in gear


Just a guess from an old shadetree mechanic: pedal pressure is wrong-too weak, or the clutch pressure plate bolted to the flywheel is bad. They will wear on the fingers and the plate's springs can wear. There should be a Case repair facility at a dealership, anywhere close? A mechanic familiar with your case 580, they often don't mind talking a bit over the phone about a mechanical problem. I meant by pedal pressure-I don't know if the rig is hydraulic clutch or mechanical linkage or cable operated, but check if the clutch pedal can be adjusted. On a hydraulic clutch with a clutch master cylinder and an associated slave cylinder, there is no adjustment. You just have to keep the reservoir full of dot-3, or dot-4 brake fluid. So that's my guess, something wrong with the pedal, or worse, something wrong with the pressure plate. You definitely need a second opinion. Good luck.

Jan 25, 2013 | Cars & Trucks

2 Answers

I have a Case IH 5230 Maxxum tractor with shuttle hesitation.


I have a 1974 case backhoe 580 it will not move in any gear.

Jul 10, 2009 | Milwaukee Tool Case Heat Gun

2 Answers

Case 580C model 33 backhoe - transmission problems


Pregunta , tienes, el manual de la case 580 ck, donde se muestra el circuito hidrailico de la transmision, si es asi, embiame una foto del circuito o el manual y te puedo apoyar.

Apr 29, 2009 | Ertl 580 Super M Series II Tractor

Not finding what you are looking for?
The Times Case Corporation Tractors International Harvestor Logo

Related Topics:

625 people viewed this question

Ask a Question

Usually answered in minutes!

Top The Times Toys Experts

kakima

Level 3 Expert

102366 Answers

yadayada
yadayada

Level 3 Expert

75066 Answers

ray gallant

Level 3 Expert

41466 Answers

Are you a The Times Toy Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...