Question about Televison & Video

1 Answer

Picture bounces I have a panasonic projection flat screen tv (pt-51sx60a) the picture starts bouncing randomly especially with shows containing britgh colors such as cartoons. Some picture distortion with picture elongation.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Vice President:

    An expert whose answer gotĀ voted for 100 times.

    Sniper:

    An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

  • Expert
  • 92 Answers

Chances are the mirror is out of allignment or loose that projects the image on the screen from the lights below. This is a delicate adjustment that should be done by a professional service center. I hope this helps, good luck.

Posted on Sep 24, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My panasonic PT-51SX60A has a 2 inch picture loss


tv looks fine then I get just a line in middle and nothing else

Jul 24, 2010 | Panasonic PT-51SX60 51" Rear Projection...

1 Answer

Picture bounces and becomes like an hourglass only sometimes, mostly when there are words on the screen


Ur tv have convergence problems.The 2 convergence ICS it not total dead yet,but it going to.Must know how to solders.Must replaced 2 convergence ICS,and some of it resistors.Tries Tv repair World.com to buy a Convergence kit to repair it ur self.The shop will cost u $300 for parts and labors.

Mar 27, 2010 | Panasonic PT-51G43 51 in. Rear Projection...

1 Answer

Panasonic multimedia projection HDGT tv color spots displayed


PANASONIC..PT-52LCX15. STARTED TO A LIGHT COMES ON THE SCREEN. THEN TWO LIGHTS. FINALLY TV DONT COMES ON. I PUT ON THE TV, AND ON BOTTON START BLINKING AND TV DONT COME ON..I TAKE OUT THE TV LAMP..IT LOOKS GOOD NOT BURN. SHOULD I REPLACE IT??

Oct 18, 2009 | Panasonic Televison & Video

1 Answer

Mt pt-47wx49e is showing a blurry picture that bounces and waves. ive tried adjusting the convergence on the set but dont have a remote and its tricky to do on the set top controls but i dont think its...


Convergence chip could be lose as in solder joints bad sometimes a good slap on the TV side will straighten this out temporarily but not recommended. A service call is the best fix unless your handy at taking it apart and resoldering the chip you can find convergence kits online if you are the handy type :)

Sep 29, 2009 | Panasonic PT-47WX49 47" Rear Projection...

1 Answer

TV screen bouncing up and down


look for the horizontal hold.

Jan 26, 2009 | Akai PDP4206EA Television

1 Answer

Television picture


Is it bouncing in and out or just blury? If its bouncing in and out you can get a repair kit on www.magnavoxhelp.com. If its blury my guess is that the convergence IC's STK-392-120 are bad.

Aug 04, 2008 | Philips 60PP9202 60" Rear Projection...

1 Answer

Bouncing Picture on WS48511 MITSUBISHI PROJECTION TV


I have seen this symptom a lot recently. There is a 9 volt regulator on the small signal board, and the output voltage on this IC has dropped down to about 8 volts, which causes that symptom. Replacing that regulator should cure your problem, and when I make a housecall for a set like that I charge $150, although I hear that the average service center charges a lot more than that. I also believe that it is never a good idea to leave a projection TV on all the time, so whoever told you that has no idea what they are talking about.

Jul 05, 2007 | Mitsubishi WS48511 48" Rear Projection...

1 Answer

Problem with picture


could be a bad solder connection or a bad cap in the vertical section. see a repair man in your area

Dec 12, 2006 | Panasonic PT-56TW53 56" Rear Projection...

Not finding what you are looking for?
Televison & Video Logo

Related Topics:

167 people viewed this question

Ask a Question

Usually answered in minutes!

Top Televison & Video Experts

The Knight
The Knight

Level 3 Expert

73619 Answers

Cindy Wells

Level 3 Expert

5056 Answers

Electro Med Services...
Electro Med Services...

Level 3 Expert

6694 Answers

Are you a Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...