I have a vonage router that only has one blinking blue light....has worked fine for 5 years now is not even after rebooting. Help?

The lights will blink indicating activity. Much like your HDD, DVD/CD drive light blinks with activity. Correct me if I am not understanding your question, "monitor lamps". Has this been happening for a long time, just started? How many years have you had the wireless access point? If you reboot the device does it complete the self-test?

A Blinking Power LED means that the firmware is corrupt. Try holding the reset button for 30 seconds and letting it go through its reboot cycle.

Please remember to rate my solution to show your appreciation.

Amardeep
For more tips visit my blog at http://thegeektweet.wordpress.com

It should work with the Vonage hooked into the WAN port of the modem, then the router plugged into the router. I had same issue with a Belkin router. Vonage Customer Service will help you at all hours: 1-VONAGE-HELP (1-866-243-4357)
24 hours a day, 7 days a week If you are calling to speak to our technical support team, please make sure you are near the Vonage phone adapter you are calling about and at the location where you intend to use your Vonage service.

If I could be of further assistance, let me know. If this helps or solves the issue, please rate it and give a testimonial for my response. Thanks, Joe


I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_8b8c2cd6ce148309

First check your circuit breaker or fuses to make sure all are operating. Sometimes a power outage results in a line spike that burns out electronics.

If you are certain that you have power to the receptacles, then you masy want to try to put a claim into your power company for replacement of the electronics.

If you have a regular phone, then connect it directly to the Vonage phone router. Be sure and connect to the correct port on the router (mine has 2 ports, and I use both, but a single line subscriber would only hook to Line 1).
See if you get a dial tone with the standard phone hooked up (we are testing that the Vonage is good.first, then we'll deal with the Uniden phone.). If not, what do the light's indicate on the Vonage router? Have you subscribed to Vonage? Do you have a cable between your router and the Vonage router?

Reply back back what you find and I can help you more.

Make sure your the internet is working fine on the router. If it is, you need to call vonage and have them activate the phone ports of the router. The phone ports on the back of the router needs to be registered first through vonage. That should do it.

If you plugged a telephone into your D-link router, unplug it - that can not work!
You have to plug your vonage router (WAN port) into the D-Link (LAN port) and connect your phone to one of the LAN ports of the vonage router.

If you do not need the wireless capabilities of the D-Link, you can simply take that one out and only use your vonage router.

If you need more help, I would need more details form you:
Which vonage adapter are you using?
How is your setup (i.e. modem -> D-link -> vonage & computers)
What connections are you using (wire/wireless)?

You can also find help here.

I am new in the network field.How can i set up a LAN net work using 5 hosts.What are the devices that I need to set up this net work?This is my email address.You can send it there:[email protected] thanks

could be a faulty transformer,,,,is the transformer stone cold or warm to the touch? i would exchenge for another

try this resolution provided by me earlier. In any case if this doesnt work, you may initiate a chat with me and we can carr on from there... http://www.fixya.com/support/t139545-configure_router Good luck