Question about Jensen XA4150 Car Audio Amplifier

1 Answer

I have a jensen ka5 4channel amp

My amp just started to smoke what cud be rong

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 143 Answers

What were the events leading upto this problem?

Where you installing it?

Was it working fine for a long time prior?

Posted on Dec 15, 2007

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 yamaha snowmoble 500 venture with twin mukuni carbs recently cleaned wont idle need throttle and choke to start,starts ok,no throttle,sled stalls out.


may need a rebuild on carb or jet ajust--secure a repair manual for procedures--pro advice is often needed for carbs cause if done rong u cud fry engine

Feb 26, 2013 | Motorcycles

1 Answer

Why is my amp smoking when hooked to my battery


if its new and it smoked you need to run it to the ignition fuse in your car and see what happens if it still does it its fried

Sep 04, 2012 | Jensen Car Audio & Video

2 Answers

Fitted new stater motor still clicking


THE FLYWHEEL TOOTH PROBABLY ARE WORN

Mar 29, 2012 | Cars & Trucks

1 Answer

Door wont lock befor i start washing mashine after i fixd handel wa cud be rong


door locks can be tricky did you replace the complete door assembly with new ?
and did you brake the door handle that is why you fitted a new one ?
have you also replaced the inner door lock?
let me know

Dec 10, 2011 | AEG Lavamat 16810 Front Load Washer/Dryer

2 Answers

My truck had a tune up and everything was good ...then is started to sound like it was missing...then i stalled...has gas...has spark


the mechanic may hav a plug wire on rong plug or the wires cud be old and they were pulled on--the distributer cap cud hav corrosion-chec it--inspect injector connections-mite hav been disturbed--fuel filter may be put in backwards--many techs dont test drive vehicles

May 12, 2011 | 1991 GMC Sonoma

1 Answer

Hi ive got a 2003 rm 250 ive just changed the crank shaft seal and the bike is still smoking but not as bad cud i have oil in my packing in my back box of my exhaust or have i another problem? And the bike...


I would suggest doing a compression check and checking the results against your manual (should be at least 165PSI or so. Low compression will make the bike run rich which would make it smoke excessively. It would also make it hard to start and run poorly with low power. New rings could do wonders.

Scott

Feb 23, 2011 | 2003 Suzuki RM 250

1 Answer

My little chief smoker never got the fish I was smoking to 140 deg.I had this unit smoking for two & half hrs. is this normal?


How old is the smoker? Is the heat element old, weak (maybe needs replacing?) Did you save the cardboard box the smoker unit comes in and place it over the smoker for the actual smoking process? This is recommended by the manufacturer and keeps the smoke and heat in, and gets you up to temperature. see also www.smokehouseproducts.com

Jul 02, 2009 | Luhr Jensen Little Chief 9800

1 Answer

Smoking


wiring is conected the rong way ,,cheers

Apr 11, 2009 | Dewalt DC925B Heavy Duty Xrp 18V Cordless...

1 Answer

Problem wth printer


young dons...you may need new drivers

go here to get em..

Jan 05, 2008 | Lexmark Z640 InkJet Printer

1 Answer

Jensen xa2150 amplifier


Check and see if its dirty inside, dust and smoke are known to cause problems via shorting or not making contact... sometimes your fuses are a bit over the wall so it would be best to replace them... and check if you have a fuse between your battery and the power cable to avoid over powering the amp

Dec 18, 2007 | Jensen XA2150 Car Audio Amplifier

Not finding what you are looking for?
Jensen XA4150 Car Audio Amplifier Logo

Related Topics:

180 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jensen Car Audio & Video Experts

xxxxxx xxx

Level 3 Expert

4915 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

The Knight
The Knight

Level 3 Expert

75169 Answers

Are you a Jensen Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...