Question about Dryers

1 Answer

Kitchenaid prestige dryer model keys677EQ1

Dryer run for few min. stop after it gets hot. will not run again for a while

Posted by on

  • Anonymous Mar 06, 2009

    overheats and shuts off

  • Melissa Hendon
    Melissa Hendon May 18, 2009

    the dryer starts then stops. at this point I am pushing every botton cord ect. to start the thing.

×

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I have a KItchenAid Presitge Electric Dryer; Model #YKEYS677EQO. It just shut off. I tried resarting it but all I get is a humming noise. This humming noise only lasts for about a couple of seconds then I get nothing. The barrel can be turned manually.

Posted on Mar 25, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

E 64 code on a Frigidaire affinity dryer, but still getting heat. What could be the problem?


that has three sets of coils in it,one of them is bad this is most likely why you still have heat,i've seen it a few times,change out the heater box,go here and look at the last picture,you'll see the three sets of coils one of them is broken,just order your heater box for your model number off of your dryer.change out the heater box
https://www.appliancezone.net/134792700-frigidaire-dryer-heating-element-replacement/?gclid=Cj0KCQiAvrfSBRC2ARIsAFumcm_UzfGwntvtSVc9IDruzrS145S-0pcaF2W7iBwEOgT2y1r4boAgEPAaAoi4EALw_wcB

Jan 04, 2018 | Frigidaire Dryers

3 Answers

Dryer stops tumbling, but heating element stays on


Usually when an electric dryer overheats it's because of a defective cycling thermostat or a clogged vent system. Clean any lint from the internal and external ductwork, and/or replace the cycling thermostat

May 18, 2008 | GE DBXR463EBWW Electric Dryer

1 Answer

I have a kitchenaid prestige gas clothes dryer. Model #KGYS677EQ1 . It is producing no heat at all, but it is tumbling fine. Can you please help me figure out the problem?


It could be a few things, but the most common is the heating element is burned out. Un-plug the dryer. Remove the cover to expose the wires attached to the heating element. Take a Ohm meter to test the heating element after the wires are un-plugged.

May 21, 2014 | Dryers

1 Answer

Kitchenaid prestige dryer not heating


I worked on a similar dryer with the kenmore brand on halloween. nothing had been done to the dryer since it was new. Take a look:

Kenmore 4-wheel drive dryer de-mystified!



If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Feb 05, 2013 | KitchenAid Dryers

1 Answer

Dryer shuts down within 5 mins of running


your vent is plugged up move dryer away from wall and allow room for vent

Mar 25, 2009 | Whirlpool Dryers

1 Answer

Dryer gets hot and turns off timmer still going,wont restart for approx 20 min


there is a thermal switch it cuts out the heater element when its at temp. also so has a thermal switch that cut out the unit if it gets to hot. there will be two thermal switches or a combined one. it will have 2 to 3 wire on it and is directly connected to the the drum. one of these is the problem the thermal switch is working as its cutting out the unit. to stop a fire.

Jun 18, 2017 | Whirlpool GEW9878LW Electric Dryer

1 Answer

Kitchenaid dryer


Yank the filter out the top.
remove the 2 phillips screws in that filter housing on the top of the machine so you can pop the spring clips and get the top up. Remove the front and get the drum out. Oil the wheels and idler and rerout the belt using this PIC.


If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Jul 30, 2008 | Kenmore 62802 Electric Dryer

1 Answer

TDC 30 Dryer starts but after 5 mins "clicks and stops"


its probably the relay (brown plastic box at the front under lid)! Symptoms are usually.... the dryer will go for a few minutes then shut down.... then you have to wait for it to start

May 23, 2008 | Hotpoint TDC32 Electric Dryer

Not finding what you are looking for?
Dryers Logo

Related Topics:

859 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dryers Experts

yadayada
yadayada

Level 3 Expert

80407 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Brad Brown

Level 3 Expert

17326 Answers

Are you a Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...